Pinghu Wellye Electrical TX4 Remote Control User Manual
- June 6, 2024
- Pinghu Wellye Electrical
Table of Contents
**Pinghu**
Operation manual: For the first time to use Need to frequency bind Take out the remote control, install the battery Long press on the button “M” for 2-4 seconds,Indicator light will flash Turn on the power of the car, Indicator light flashes to longing thing, then frequency binds ceed If the frequency bind failed(lndicator light flashes), remove the battery and repeat steps 1~3 remote control without operation after l0 seconds, the Indicator light will of into power saving mode Button Description: forward backward turnleft turnrightS:Speed P: emergency brake, pressing the running function will fail, press again, release
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help. This
device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>