Pinghu Wellye Electrical WYTX19 Remote Control User Manual
- June 6, 2024
- Pinghu Wellye Electrical
Table of Contents
Pinghu Wellye Electrical WYTX19 Remote Control
Operation manual
For the first time to use Need to frequency bind Take out the remote control,
install the battery Long press on the button “ M ” for 2-4 seconds,
Indicator light will flash Turn on the power of the car, Indicator light
flashes to long lighting, then frequency bind succeed If the frequency bind
failed (lndicator light flashes), remove the battery and repeat steps 1~3
remote control without operation after 10 seconds, Indicator light will off
into power saving mode Button Description: 
forward 
backward turnleft turn right S: Speed P:
emergencybrake, pressit and the running function will fail, press again, it
release.
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>