zortrax M200 Glass Plate Installation Guide
- June 6, 2024
- zortrax
Table of Contents
zortrax M200 Glass Plate
SOURCE:
https://support.zortrax.com/glass-plate-installation/
Unplugging the Power Cable
Turn the printer
off and unplug the power cable.
Platform removal
Unplug the heatbed
cable and carefully remove the platform from the printer.
Perforated Plate Removal
Unscrew the twelve screws that secure the perforated plate to the heatbed.
Next, separate the plate from the heatbed.
For the M300 Plus, unplug the perforated plate cable before separating the
plate from heatbed.
Cleaning the Heatbed
Clean the heatbed from material residues using a piece of cloth.
Pogo Pin Module Removal*
Turn the heatbed over and unscrew the two screws that secure the pogo pin
module. Next, remove the module.
*This step applies only to the M200 Plus.
Glass Plate Installation
Place the glass plate on the heatbed.
Securing the Glass Plate, part 1
Install the four
corner clips and secure them with the screws.
Securing the Glass Plate, part 2
Install the two
push-on side clips.
Platform Installation
Place the platform
in the printer and plug the heatbed cable in. Next, start the platform
calibration procedure using the options from the menu.
For the M200 Plus and M300 Plus, the only available option is manual calibration.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>