HomeSeer HS-ZWPB700 Z-Wave Interface Module Instruction Manual

June 6, 2024
HomeSeer

HomeSeer logo

HomeSeer HS-ZWPB700 Z-Wave Interface Module

HomeSeer HS-ZWPB700 Z-Wave
Interface Module product

OVERVIEW

HS-ZWPB700 is a Z-Wave interface module that’s designed to send and receive wireless
Z-Wave commands to and from compatible smart home products in the home. It is to assemble to Raspberry Pi to act as a Z-Wave controller to control the Z-Wave sensors and actuators. This module is designed in Z-Wave 700 series SiP to adopt standard S2 and SmartStart native protocols.

INSTALLATION

  1. Install HS-ZWPB700 onto RaspBerry Pi via the 12-pin connector.HomeSeer HS-ZWPB700 Z-Wave Interface Module fig-1
  2. Open SSH via Putty platform to connect RaspBarry Pi.
  •   Enter the user ,
  • Enter your password,
  • Enter the commands,
    • sudo nano /boot/config.txt
  • Add below line,
    • dtoverlay=pi3-disable-bt
    • enable_uart=1
  • Exit the editor with Ctrl X and save with Y,
  • Reboot the system,
    • sudo reboot
  • Login SSH again and enter the username & password,
  • Check if the port ttyAMA0 is available with
    • dmesg | grep tty

HomeSeer HS-ZWPB700 Z-Wave Interface Module fig-2

NEED HELP?

You can get help in several ways:

This product employs or practices certain features and/or methods of the following U.S. Patents: U.S. Patent Nos.6,891,838, 6,914,893 and 7,103,511.

FCC STATEMENT

THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UN-AUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE US-ER’S AUTHORITY TO OPERATE THE EQUIPMENT. STORE INDOORS WHEN NOT IN USE. SUITABLE FOR DRY LOCATIONS ONLY. DO NOT IMMERSE IN WATER. NOT FOR USE WHERE DIRECTLY EX-POSED TO WATER. This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions:

  1. This device may not cause harmful interference,
  2. This device must accept any interference received, including interference that may cause undesired operation.

This equipment comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used according to instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in any given installation.

SPECIFICATIONS

  • Z-Wave Chip Type
  • Z-Wave SDK 7.15 (or later)
  • Z-Wave Frequency 908 MHz (US)
  • Wireless Range U p To 300 Ft LOS
  • Operating Temp Range 0ºC to +40ºC
  • Power & Data UART
  • Certifications Z-Wave PlusTM
  • Dimensions 2.16 x 1.22 x 0.5 (inches)

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals