REMINGTON MB6850 Vacuum Beard and Stubble Trimmer Instruction Manual

Vacuum Beard and Stubble Trimmer
MB6850
remington-europe.com

Thank you for buying your new Remington® product. Please read these instructions carefully and keep them safe. Remove all packaging before use.

IMPORTANT SAFEGUARDS

• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been supervised/instructed and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be done by children unless they are older than 8 and supervised. Keep the appliance and cable out of reach of children under 8 years.
   Do not use this appliance near bathtubs, showers, basins or other vessels containing water.

• Do not use the product with a damaged cord. A replacement can be obtained via our International Service Centres.

• This product should only be used with the charging adaptor supplied.

• WARNING: Keep the appliance dry.

• Do not use the appliance, charging adaptor, or any other part if it is damaged, as this may cause injury. Always replace a damaged charging adaptor with one of the original type.

• The charging adaptor contains a transformer. Do not cut off the adaptor to replace it with another plug, as this causes a hazardous situation.

• Do not immerse the charging adaptor in water or any other liquid, nor rinse it under the tap.

• This appliance should never be left unattended when plugged into a power outlet, except when charging.

• Keep the power plug and cord away from heated surfaces.

• Do not plug or unplug the appliance with wet hands.

• Do not twist or kink the cable, or wrap it round the appliance.

• This appliance is not intended for commercial or salon use.

PARTS

1. On/off switch
2. Main blade
3. Vacuum intake
4. Vacuum chamber
5. Vacuum chamber release buttons
6. Detail blade
7. Adjustable beard comb 2 – 18mm| 8. Charge indicator light
9. Charger connector
10. Comb lock button
11. Charging adapter (not shown)
12. Storage case (not shown)
13. Cleaning brush (not shown)
---|---

CHARGING

Charge the device:

• Before using for the first time.
• When the charge indicator light is flashing.
• After it has not been used for a long time.

1. Ensure the product is switched off.
2. Connect the product to the adaptor and then to the mains.
3. When charging, the charge indicator light will light up. The light will go out when charging is complete.
4. A first time charge should take approximately 2-4 hours. Top up charges should take approximately 2 hours.
   • To preserve the life of your batteries, let them run out every 6 months then fully charge.

CORDED/CORDLESS USE

• When fully charged, your trimmer should provide approximately 60 minutes of cordlessuse.
• You can also connect the charger (as if you were going to charge the trimmer) and operate the trimmer ‘corded’ if desired.

ATTACHMENTS

EXCHANGING THE MAIN AND DETAIL BLADES
Your trimmer is supplied with the main blade already fitted. It is easier to remove and refit the main blade with the vacuum chamber removed.

1. Switch your trimmer off.
2. Hold the trimmer in one hand.
3. Push the top of the blade away from the trimmer body using your thumb (Fig A)
4. Use enough force to free the blade from the trimmer body. Once free, lift it off.
5. Fit the desired blade by engaging the tab on the back of the blade into the rear of your trimmer. Press the front of the blade down until it clicks.
6. Replace the vacuum chamber.

FITTING/REMOVING THE ADJUSTABLE BEARD COMB

1. Switch your trimmer off.
2. Depress the comb lock button then slide the adjustable comb into the guides on the rear of your trimmer. Slide the comb all the way down then release the button.
3. To adjust the length of the beard comb, depress the comb lock button then slide the comb to the desired length.

INSTRUCTIONS FOR USE

TRIMMING YOUR BEARD

For even cutting, allow your trimmer to cut its way through the beard hair. Do not force it through quickly. If you are cutting for the first time, start with the maximum comb length attachment.

Regularly check the level of collected hair in the vacuum chamber. When full, switch off your  NO trimmer and remove the vacuum chamber. Empty the hair clippings. Refit the vacuum chamber before continuing use.

THINNING OR TAPERING THE BEARD OR MOUSTACHE

1. Set the adjustable comb to the desired length.
2. Place the flat part of the comb against the skin. Slowly slide the comb through the hair.
3. Repeat from different directions as necessary.
4. If hair builds up in the trimmer comb during the trimming process, switch the unit off, remove the comb and brush off the hair.

DEFING THE LINE OF THE BEARD OR MOUSTACHE

1. Remove the main blade and replace it with the detail blade.
2. Start trimming at the edges of your beard/moustache line.
3. Move your trimmer carefully towards the line until the desired shape is achieved.

TRIMMING YOUR SIDEBURNS

1. Fit the wide trimming head, or the detail trimming head as requried.
2. Hold your trimmer with blade facing you.
3. Start with edge of your sideburns. With the trimmer blade resting lightly against your skin, move your trimmer carefully towards your sideburn until the desired shape is
   achieved.

TRIMMING THE NAPE OF YOUR NECK

1. Remove the adjustable comb.
2. Use the fingers of one hand to lift the hair at the base of your head up off your neck.
3. Your index finger should be covering the roots of the hairs you are lifting to prevent them from being accidentally cut.
4. Hold the trimmer to the base of your neck with the blade facing up. Move the trimmer up the neck until it touches your index finger which is protecting the hair roots.
5. Take out the battery and printed circuit board assembly from the battery chamber.
6. Cut the tabs on both ends of the battery and remove it from the printed circuit board
   • The battery must be disposed of at an appropriate official recycling/collection point.
   • Do not attempt to operate the trimmer once you have opened it.

RECYCLING

To avoid environmental and health problems due to hazardous substances, appliances and rechargeable and non-rechargeable batteries marked with one of these symbols must not be disposed of with unsorted municipal waste. Always dispose of electrical and electronic products and, where applicable, rechargeable and non-rechargeable batteries, at an appropriate official recycling/ collection point.

ADAPTER SPECIFICATIONS

Manufacturer address and registration number| Spectrum Brands (UK) Limited, Regent Mill, Fir Street, Failsworth, Manchester M35 0HS
Company number: 02394603
---|---
Adapter model number| PA-0515U
Input voltage| 100 – 240 V~
Input AC Frequency| 50/60Hz
Output voltage| 5.0 V
Output current| 1.5 A
Output power| 7. 5 W
Average active efficiency| ≥76.65%
Efficiency at 10%| –
No load power consumption| ≤0.1W

Ref. No. MB6850
Type No. MB6850
21/INT/ MB6850 T22-7002124 Version 04 /21
Remington® is a Registered Trade Mark of Spectrum Brands,Inc.,
or one of its subsidiaries
Russell Hobbs Deutschland GmbH, Am Unisyspark 1, 65843 Sulzbach, Germany
remington-europe.com
© 2021 Spectrum Brands, Inc.

References

• Remington - EST. NEW YORK 1937 | Haircare & Personal Care Appliances for Men & Women

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>