IKEA Sonos Wireless Speaker User Manual
- June 6, 2024
- Ikea
Table of Contents
IKEA Sonos Wireless Speaker
FCC Statment
FCC ID: FHO-920-00632 and IC: 10912A-92000632
Module description: There are two different radios in the Wireless Module. The
first radio supports WiFi wireless Ethernet based on the IEEE 802.11 a/b/g/n
standards. The 2.4 GHz communication is limited to channels 1-11 for North
America. The 5 GHz communication is controlled based on regional regulatory
requirements. The second radio supports Bluetooth Low Energy (BLE) mode
(v4.2). Support for BLE is through a dedicated chip. Operation in BLE mode is
supported in the required 2.4 GHz ISM band on channels 0-39. In addition to
the radios, the Wireless Module supports wired Ethernet communication (IEEE
802.3 100Base-TX) by using Ethernet port. In this mode of operation, the WiFi
wireless Ethernet is disabled.
Note: Wireless Module labeled with “FCC ID: FHO-920-00632” is not capable of
transmitting on 2.4GHz
Channels 12 & 13. This FCC ID does not appear on the product label of non-USA
product versions (SKUs).
Saftey
When using an electrical device, basic precautions should always be followed,
including the following:To reduce the risk of burns, fire, electric
shock, or injury to persons:
- Unplug from the outlet before putting on or taking off parts.
- Close supervision is necessary when this device is used by, or near children, invalids, or disabled persons.
- Never operate this device if it has a damaged cord or plug if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the device to a service center for examination and repair.
- Keep the cord away from heated surfaces
- Do not use outdoors.
Advice and instructions for Wireless Module
- Sound level: Lower than 55 dB(A).
- Temperature interval at usage: +10 °C up to + 40 °C/+50 up to +104 °F.
- Temperature interval at storage: -18°C up to 70°C/0 up to 158°F
- Humidity: 20% up to 90% at 40°C/104°F.
- Power supply unit: The module is power by a specified DC supply that is mains connected. The power supply is certified for its intended usage and evaluated for saftey
This appliance shall only be used together with the matching DC power supply.
Installation instructions
- Install module in host product with screws and hand tighten. Install all connectors from the host product to the wireless module.
- Place the electrical cables so that they do not get damaged, see assembly instruction.
- Connect the electrical cable to a wall socket.
Usage of the Wireless Module
where the authorization was granted. IKEA strongly discourages the use of the wireless module outside the bounds of the equipment authorization. This device can only be used with IKEA approved antenna with characteristics and gain that is compatible with the equipment authorization.
Operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems.
Changes or modifications not expressly approved by IKEA could void the user’s
authority to operate the equipment.
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may
cause undesired operation of the device.
To ensure compliance with FCC and ISED RF exposure requirements this device must be installed to provide a minimum of 20cm between the device and people.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>