GE current A1019051 Evolve LED Hazardous Location Flood Installation Guide
- June 6, 2024
- GE current
Table of Contents
**Installation Guide
A1019051 | 99008144
Evolve ™ LED Hazardous Location Flood
**
BEFORE YOU BEGIN
Read these instructions completely and carefully. Save these instructions for future use.
WARNING
RISK OF ELECTRIC SHOCK OR FIRE
To reduce the risk of electric shock or ignition of hazardous atmospheres,
disconnect the luminaire from the supply circuit before opening. Keep tightly
closed when in operation.
RISK OF INJURY OR DAMAGE
Unit will fall if not installed properly. Follow installation instructions.
CAUTION
RISK OF INJURY
Wear safety glasses and gloves during installation and servicing.
RISK OF INJURY
The luminaire should be mounted so that prolonged staring into the
luminaire at a distance closer than 0.50m is not expected.
Storage & Handling
Store packaged units in a covered dry area
Check for damage
Do not impact
Mounting-Wall & Ceiling
No vertical trunnion mounting on wall allowed.
For Class II optical aimed horizontal or downward only.
Mount to a flat surface. Bolts not included.
For 3G applications and mounting surfaces less than 16 inches, 3 bolts are required. Bolts not included.
Orient luminaire and secure side bolts.
Once desired angle, tighten bolts evenly.
WARNING
RISK OF DAMAGE
Do not torque trunnion bolts greater than 30 ft-lbs. Damage may occur.
Wiring
Loosen 3 captive screws and open the door.
Install ¾ inch NPT conduit.
Secure minimum 90°C wire to a terminal block. Do not use violet and gray dimming leads on the drivers.
CAUTION
RISK OF SHOCK OR DAMAGE
Follow applicable national and local electrical codes.
RISK OF DAMAGE
Verify supply voltage and wire insulation temperature rating match nameplate
requirements.
Door Closing
Hang door on hinge, rotate closed.
Close and fasten door.
Cleaning
Use mild soap/detergent.
Rinse with cool low pressure water.
Wipe dry with clean soft cloth.
Installation Guide
CAUTION
RISK OF DAMAGE. Do not use soap/detergent containing aromatic hydrocarbons.
Specification
Luminaire| Approx. Net Wt.| Dimensions| IP Rating Classe IP
| Effective Projected Area| Ambient Temperature
---|---|---|---|---|---
EFMH| 25 lbs (11.34 kg)| 17.1 x 18.57 x 5.147 in
(434 x 471 x 130 mm)
| ****
IP66
| 1.96 ft2 (0.18 m²)| -40° < ta < 50°C
EFHH| 35 lbs (15.9 kg)| 20 x 26.39 x 4.85 in
(508 x 670 x 123 mm)
| 3.51 ft2 (0.33 m²)| -40° < ta < 50°C
Operating Temperature Code
Luminaire
| Class I Div. 2 / Group A, B, C, & D Zone 2 Group IIA, IIB, IIC, IIB Plus Hydrogen
| Class II, Div. 2 / Group F & G Zone 22
| Class I, Div. 2 & Class II Div. 2 Simultaneous
EFMH| T3A| T3A| T3A
EFHH| T3A| T3A| T3A
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. This Class [A] RFLD
complies with the Canadian standard ICES-005. Ce DEFR de la classe [A] est
conforme à la NMB-005 du Canada.
Note: This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
These instructions do not purport to cover all details or variations in
equipment nor to provide for every possible contingency to be met in
connection with installation, operation, or maintenance. Should further
information be desired or should particular problems arise which are not
covered sufficiently for the purchaser’s purposes, the matter should be
referred to Current.
Evolve™ EFHH/EFMH-Series
© 2021 Current Lighting Solutions, LLC. All rights reserved. GE and the GE
monogram are trademarks of the General Electric Company and are used under
license. Information provided is subject to change without notice. All values
are design or typical values when measured under laboratory conditions.
www.gecurrent.com
A1019051 (Rev 03/25/21) 99008144
Documents / Resources
| GE
current A1019051 Evolve LED Hazardous Location
Flood
[pdf] Installation Guide
A1019051, Evolve LED Hazardous Location Flood, A1019051 Evolve LED Hazardous
Location Flood, LED Hazardous Location Flood, Location Flood, Flood
---|---
|
Current A1019051 Evolve LED Hazardous Location
Flood
[pdf] Installation Guide
A1019051 Evolve LED Hazardous Location Flood, A1019051, Evolve LED Hazardous
Location Flood, Hazardous Location Flood, Location Flood
| GE
current A1019051 Evolve LED Hazardous Location
Flood
[pdf] Installation Guide
A1019051, 99008144, A1019051 Evolve LED Hazardous Location Flood, Evolve LED
Hazardous Location Flood, LED Hazardous Location Flood, Hazardous Location
Flood, Location Flood, Flood
References
- Evolve® | Current - GLI Brands
- Iluminación Comercial y Controles de Iluminación | Current - GLI Brands
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>