CLEVERTOUCH WL10A-G Intelligent Environment Sensor Instruction Manual
- June 6, 2024
- CLEVERTOUCH
Table of Contents
Intelligent Environmental Sensor
Sensor Module & NFC reader for Clevertouch (WL10A-G)
Note : All the pictures in this manual are for reference only, subject to our available products.
Safety Warning
Before using and operating this device, please read thoroughly and comply with the following precautions in order to prevent accidents Or inaccurate Operations.
- Placement
DO NOT charge or use the device in dusty or wet conditions, to prevent internal circuit failure. Keep the device away from heat sources such as an electric heater. Normal operating temperature is 0-40t, normal operating humidity is 10%-90%1R11. * Children Safety
The product and accessories may contain some small—parts. Please place them beyond the reach of children in avoidance of swallowing danger. - Water Precaution
The product Is not waterproof, please keep it dry. - Maintenance
When the equipment is damaged, please do not disassemble it for repair without permission. please call customer service to report for repair. Please contact professional service personnel for maintenance services. DO NOT insert any sharp or pointed object into the device. Prevent the device from falls and collisions with other objects, which may cause damages.
Statement
- Intellectual property right statement: The hardware design and software of this product are covered by the patents. Anyone who reproduces this product or the content of the instruction without the authorization of the Company shall assume legal liabilities.
- This manual is for reference only, and the actual function of the final product is subject to the actual function of the product received by the Customer.
- The picture is for reference only, please refer to the actual product. The company reserves the right to improve and change the appearance and design of the product without notice.
Installation Procedure
Warning: Please make sure the power cord of the interactive Flat Panel (IFP) is disconnected before installation.
- Position the Sensor Box to the bottom of the IFP in the direction of the arrow.
- Lock the Sensor Box to the bottom of the FP with screws.
- Complete assembly.
FCC
Federal Communication Commission Interference Statement This equipment has
been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates. uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions. may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
The equipment complies with FCC radiation exposure limas set forth for an
uncontrolled environment.
This device complies with Part 15 of the FCC rules. Operation is subjected to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Changes or
modifications not expressly approved by the party responsible for compliance
could void your authority to operate the equipment.
- This product can be used in Europe without restrictions.
- Hereby, (Name of the manufacturer) declares that the radio equipment type (designation of the type of radio equipment] is in compliance with Directive 2014,53/EU. The full text of the EU declaration of conformity is available at the following Internet address: https://clever.touch.com.
- Frequency Range:11.810-15.310MHz
- Max. transmitting power: <25 dB u A/m ( for 3m distance)