wilfa JU1S-400 Squeezy Juicer Extractor Instruction Manual

: June 6, 2024
: Wilfa

Table of Contents

Parts and contents
Attention before use
Operating time
TIPS AND TRICKS
TROUBLESHOOTING
Maintenance and cleaning
GUARANTEE
Documents / Resources

JU1S-400 Squeezy Juicer Extractor
Instruction Manual

wilfa JU1S400 Squeezy Juicer Extractor

Please read these instructions carefully and keep for future reference.

SAFETY INSTRUCTIONS

Always disconnect the appliance from the supply if it is to be left unattended and before assembling, disassembling, or cleaning.
This appliance can be used by children aged 8 years and above if they have been given supervision or instruction concerning the use of the appliance in a safe way and if they understand the hazards involved. Cleaning and user maintenance shall not be made by children unless they are aged 8 years and above and supervised. Keep the appliance and its cord out of reach of children aged less than 8 years.
Appliances can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and if they understand the hazards involved.
Children shall not play with the appliance.
Switch off the appliance and disconnect from supply before changing accessories or working near parts that move in use.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
If the device is damaged or does not work, it must only be serviced by authorized personnel.
This machine must not be used for purposes other than those intended.
Never leave the appliance during operation.
For household use only.
Be especially aware of the “Special safety instruction” below.

Special safety instruction for this product

Before using, put this machine on a stable and flat table.
Before juicing, first, check that the strainer is fixed in position and that there is no direct contact between the strainer and the transparent cover.
Put the transparent cover on, fix the handle in place, and turn on the machine.
During initial use, the motor has a running-in phase, so there may be a slight smell and sparking. This is normal, and after the motor has run for some time the above phenomenon will disappear.
During juicing, make sure there is not too much juice and residue in the middle ring and pulp container. If too full, turn off the power supply, clean up and then use again.
During use, do not open the juicer cover. While the power supply is on, do not put your hand or any utensil in the mixing container or feed port, as otherwise a harmful accident may occur or the machine may be damaged.
In order to prolong the service life of this machine, an excess temperature protection device is mounted in the motor. If the motor is on for a lengthy period or is overloaded and the warning temperature is exceeded, the power supply will automatically cut off. After the motor stops, disconnect the power supply plug, wait for the motor to cool (about 30 min), and use it again.
When using this machine for mixing, mincing, or grinding purposes, working without load or with an excessive load is strictly prohibited.
After the operation, do not empty out the food until you have disconnected the power supply at the plug.
The cutter is very sharp, so in order to avoid danger when cleaning it, please hold the cutter under the water tap for washing, and do not wash it by hand.
Do not use the appliance if the rotating sieve or the protecting cover is damaged or has visible cracks.

Parts and contents

wilfa JU1S400 Squeezy Juicer Extractor - Parts and
contents

1. Food pusher	5. Handle
2. Transparent cover	6. Pulp container
3. Strainer	7. Main machine
4. Middle ring	8. Juicer jug

Attention before use

NOTE: This machine is equipped with a safety unit, so if the handle is not in position on the cover or the cutter part is not fixed in place, the motor will not start in order to ensure the safety of the user.

When disassembling or assembling the juicer, hold the top of the pusher bar with your hand, then force the handle in or out of the slot.
Remove the cover then raise the middle ring by holding the juicing nozzle with your hand, and lift up.
In order to avoid damage, before using, check the power supply and that it is in compliance with the rating label.
Clean all parts except the main body (see maintenance and cleaning section).
Before assembling, please read the parts and contents section carefully.
Slide the foam separator into the juice jug. This keeps the foam away when you pour the juice. The foam separator is only included with the JU2S-800 juicer.

Usage

Before usage, please make sure that the button switch is set to “0”. This will avoid starting the main machine if the assembly is not completed, thus avoiding unnecessary injury or damage to persons or property.
Before juicing, first make sure that the strainer is set in the correct position, with no direct contact between the strainer and transparent cover. Put on the transparent cover, secure the handle in the slot, and then turn on the machine.
In order to use, assemble according to the diagram in “Parts and contents”. Plug the cable into a wall socket, turn the switch on and let the machine run without load for 5 sec. Put prepared vegetables or fruit into the feeding chute and press gently down with the food pusher.

NOTE: When pressing food with the food pusher, force must be even or indirect. Pressure must not be more than 1 kg and do not use sudden force as the juicing effect will be reduced.

Operating time

This machine is designed with button switches marked O, I and II (O for stop, I for low power, II for high power).
For juicing, select high power, operate for 1 min, stop for 1 min, then repeat.
After the above operation has been performed three times, stop for 15 minutes. Do not operate until the motor is cooled, as in this way the service life of this machine will be prolonged.

TIPS AND TRICKS

Dont wait too long before you clean the juicer after use, its easier to clean if the juice and pulp is fresh.
Use fresh fruit and vegetables, as they contain more juice. Pineapples, beetroots, celery stalks, apples, cucumbers, carrots, spinach, melons, tomatoes, pomegranates, oranges, and grapes are particularly suitable for processing in the juice extractor. You do not have to remove thin peels or skins. Only thick peels, e.g. those of oranges, pineapples, and uncooked beetroot need to be removed. Also, remove the white pith of citrus fruits because it has a bitter taste.
Apple juice turns brown very quickly. To slow down this process, add a few drops of lemon juice. Fruits that contain starch, such as bananas, papayas, avocados, figs, and mangoes are not suitable for processing in the juice extractor. Use a food processor or blender to process these fruits.
Drink the juice immediately after you have extracted it. If it is exposed to air for some time, the juice will lose its taste and nutritional value.
To extract the maximum amount of juice, always press the pusher down slowly.
The juicer is not suitable for processing very hard and/or fibrous/starchy fruits or vegetables such as sugar cane.

TROUBLESHOOTING

Problem	Possible reasons	Solution

The juicer will not start

| The power cord is not plugged in| Plug into a power socket
The juicer is not assembled correctly| Assemble the juicer according to the instruction manual
The handle is not on| Push the handle into place
The juicer will not extract juice from

the fruit

| The speed is not high enough| Increase the speed to II
The vegetable/fruit is not suitable for juicing| Make sure the vegetable/fruit is fresh and suitable for juicing (see tips and tricks)
You are pressing it down too quickly| Press the fruit slowly downwards with the pusher to extract the maximum amount of juice
The juice does not flow from the spout into the juice container| The spout is not in an “open” position| Press the spout downward and the juice will pour out

Maintenance and cleaning

Please ensure that you have unplugged the machine from the socket before cleaning.
Please clean the machine within a reasonable time after use.
The main body cannot be washed directly under water; wipe it clean with a damp cloth. Other components may be washed directly with water, such as the food pusher, cover, strainer, middle ring, and pulp container.
Keep the machine dry and avoid storing in direct sunlight.
You must check that the machine is clean and dry before storing.

Technical specifications:
JU1S-400: 220-240V 50/60Hz 400W
JU2S-800: 220-240V 50/60Hz 800W

GUARANTEE

Wilfa issues a 5-year guarantee on this product from the day of purchase. The guarantee covers production failure or defects that arise during the guarantee period. Your purchase receipt works as proof towards the retailer if claiming your guarantee.
The guarantee is valid only for products that are bought and used in private households. The guarantee is not valid if the product is used commercially. The guarantee is not valid if the product is misused, used by negligence, if not following instructions given by Wilfa, if modified or if unauthorized reparation is done. The guarantee is also not valid for normal wear of the product, misuse, lack of maintenance, use of wrong electrical voltage or:

Overloading of product
Parts that are normally worn down
Parts you can expect to be replaced regularly (e.g. filter, battery, etc.)

Under the Waste Electrical and Electronic Equipment Directive (WEEE), such waste must be collected separately and processed. If in future you need to discard this product, please do not throw it out with your normal rubbish. Please send this product to a collection point where one is available.

AS WILFA
Nydalsveien 24
0484 Oslo
Norway

wilfa.com

in-home since

Documents / Resources

| wilfa JU1S-400 Squeezy Juicer Extractor [pdf] Instruction Manual
JU1S-400, JU2S-800, JU1S-400 Squeezy Juicer Extractor, Squeezy Juicer Extractor, Juicer Extractor, Extractor
---|---