Bri-moryea BR02 LED Music Night Light Star Projector User Manual
- June 6, 2024
- Bri-moryea
Table of Contents
LED Music Night Light Star Projector
User Manual
Description of the keys
Instructions for changing the direction of the pattern card
There is a prominent part upon each projector card, please insert this part to
the slot on the machine. Please promise the projector card is exactly match
with the machine, and right direction. If you make the wrong direction, the
card cannot reach the bottom, and the light will leak, the picture will be
incomplete.
Technical Parameters
| LED Light Source | 4X2W 4 1X1W |
|---|---|
| Source Lifetime | Rated 200,000 hours |
| Power Supply DC | 5V 1.5A |
| Speaker Power | 5W |
| Effect | Night Light Star Projector |
| Remote control distance | 5 meters |
| Audio Connector name | BRO2 |
| Projection distance | The best projection distance is 3-5 meters |
Remote Control Panel Introduction How to play music
- Turn on the switch button on the machine
- Turn on the Bluetooth on your phone
- Search the signal to find “BR02”, please connect. (If cannot connect the signal, please try to switch off the power, and reset, do the above action again
- Play the music by the App on your phone how to control the voice? Please adjust your Bluetooth volume first, and then make a long press on 3th and 4th buttons on the machine, the last make a long press for the button on the remote controller. (The original voice from switch-on is: 50%, and you can adjust to 100% by machine button or remote controller)
Attention
- Please switch on the button on the machine and then all other buttons are available. If the device does not work after turning on the power, please make recharge with the adapter less than DC5V 2A . It needs 3-5 hours to make it fully rechargeable.
- Please do not look directly at the light for a long time if use it during the night time
- The remote control is infrared control, so please use it against the IR receiver on the machine, and the IR control distance is 3-5 meters.
- Please do not use the bracket with a long screw, or the speaker will not get perfect sound if the screw touches the speaker
- If the remote controller is lost, please control it by ” mode ” button on the device
- Please Turn off the power if not use
- It is an indoor product, so please stay it away from water
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>