Shenzhen Three Bees E Commerce FC220 Charging Stand User Manual
- June 6, 2024
- Shenzhen Three Bees E Commerce
Table of Contents
FC220 USER MANUAL
Product name:
automatic tracking wireless charger stand
- Search LED
- TX Coil
- Infrared induction
- Guide LED
- USB
How to use:
A. Charge horizontally
B. Charge vertically
Input and output:
Input: 9V-12V, .?_2A | Input: 9V-12V, .?_2A |
---|
Indicator light modes:
Power-on: The indicator light is on once, and the LOGO light is on for
calibration;
Standby: The indicator light is off and the LOGO light is on; In charging: The
indicator light is on and the LOGO light is off; A foreign object is detected
during charging, and the indicator light flashes.
Attentions: light flashes.
A. Each time connected with power, the LOGO light will move up and down for
about 15 seconds; each time for charging, the coil will automatically track
and calibrate, which will take about 10 seconds.
B. Please use a PD or QC adapter with a power greater than 18W, and a type c
cable of 2A and above.
C.During usage, if the coil moves abnormally, please unplug and re-plug the
power cord, and then it can work normally.
D.Place the mobile phone for charging, try to be centered and close to the
mirror surface vertically.
E.During the charging process, metal objects should not be placed in the
center of the mobile phone coil to avoid abnormal charging.
F.Usually we recommend that the thickness of the phone case should be within
3mm(0.12inch),it would not charge if the thickness is more than 5mm(0.19inch).
G.We recommend that you turn off the power-consumption software before
charging to effectively prevent the phone from overheating. When the
temperature exceeds 113°F during charging,it is normal for the charging speed
to slow down.
H.Keep the charger away from water and other liquids.
I.Do does not use at high temperatures.
J.Do does not squeeze or beat violently.
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation. Warning: Changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20cm between the radiator & your body.