MEEWER NW48-2.4G LED Softbox Lighting Kit Instruction Manual
- June 6, 2024
- MEEWER
Table of Contents
MEEWER NW48-2.4G LED Softbox Lighting Kit
Installation instructions
- Firstly, insert the white pin end of a steel wire into the light head.
- Put the other end into one corner of the softbox.
- When the first wire is placed in place,you must install the second one in the diagonal direction. 4 Then put the rest of two steel wires in place in the same way.
- Connect the joint part of the softbox with the light head through the fastening tape.
- Place the colored plastic sheet in the slot in front of the light and press the colored plastic sheet to rotate to the left. Skip this step if you do not use colored plastic sheets.
- Attach the diffuser onto the softbox.
- Finally,mount the softbox on the stand.
Remote control instructions
Product Information
The NW48-2.4G has 168 pcs premium LED breads output is
48W, the LED bread has less heat to increase the lifespan.The shell is high-
strength ABS sturdy and durable, beautiful and fashionable, it’s light and
handy simple design easy to carry. Make the live show more effective. It’s
simple to operate,stepless dimmer, and Bi-color. Powered by 2 pcs lithium
battery or external DC power supply.
Packing Accessories
Model Parameter List
Overview
- CH +/- key: CH 1 ~CH4, showing on the top left corner of the LCD display.
- Color temperature knob: The Color temperature range is 3200K-5600K, showing on LCD display.
- Power plug socket: External DC13-19V power input
- Battery Location: If you don’t use power supply, you can install NP-F550/970 Li-ion batteries (not included) here.
- LCD Display: The display shows the brightness and color temperature data. The battery remaining capacity is displayed in the upper right corner of the screen. “Lo” means low power. “OF” means light off.
- Dimmer knob: The brightness range is 10%-100%,showing on LCD display .
- Power switch : = :External DC power on;-: Battery power on
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>