Shenzhen Lingchuangxun Technology LCX-ZJ300 WiFi Repeater Installation Guide
- June 6, 2024
- Shenzhen Lingchuangxun Technology
Table of Contents
Shenzhen Lingchuangxun Technology LCX-ZJ300 WiFi Repeater
The equipment complies with the FCC Radiation exposure limit set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body.
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Statement: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and Connect the equipment into
an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
LED Explanation:
Quick Installation
FAQ ( Frequently Asked Questions )
Q1: What should I do if I cannot access Repeater’s s web management page?
:
A 1: Make sure your computer is connected to the extended network.
A2: Make sure , lour computer is set to obtain an IP address automatically.
A3: If the Repeater has connected to the router,you should go to your router ‘
s
DHCP clien~ nst to obtain the Repeater ‘ s current IP address.A4: Reset the
Repeater.
Q2: Why does f;he wireless transmission rate speed down, when the
wireless
———–signa~is-s~ongerafterrepeated-by-the repeater? —————————— –
A 1: In compliance with the wireless transmission protocol,all the Repeater
devices are set to work ln half-duplex instead of full-duplex mode.In other
words,the Repeater has to process one-way communication between your root
Wireless router(or Af) and the terminal clients: so the transmission time will
be double-incrr:,ased,while the speed will be decreased. Recommends that you
connect to ~he extender when your home network connection is poor,or when you
want a larger wireless coverage to eliminate “dead zones” .
Q3: Why the devices connected to the Repeater cannot get an IP address from
the Repeater and cannot access the Internet?
A 1: Maybe you enabled a wireless MAC filter ,wireless access control,or
access control list(4CL) on your router. To solve this problem,please log into
your router and <:Usable the MAC fllter,wireless access control or AGL. A2:
Maybe the ~epeater has not been successfully connected to your router, please
reset the Repeater and Reconfiguration. A3:Maybe the IP address of the router
is occupied or the wireless deviceconnected tjy the router has reached the
limit. please reboot your router,then reset t~e Repeater and Reconfiguration.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>