TRANSCORE 10-4002-002 Encompass 4 RFID Reader User Guide

: June 6, 2024
: TRANSCORE

Table of Contents

TRANSCORE 10-4002-002 Encompass 4 RFID Reader
Encompass 4 Reader System Guide
FCC Statment
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

TRANSCORE 10-4002-002 Encompass 4 RFID Reader

TransCore’s Encompass 4 Reader System is a dual-protocol reader that reads TransCore Super eGo® (SeGo), eGo, American Trucking Associations/International Organization for Standardization (ATA/ISO), or Inter-Agency Group (IAG) tag protocols. This guide provides site planning and testing, installing, and operating instructions. This information is intended for use by authorized TransCore dealers, installers, and service personnel.

Encompass 4 Reader System Guide

© 2009-2022 TransCore, LP. All rights reserved. TransCore, AMTECH, EGO, and ENCOMPASS are registered trademarks and are used under license. All other trademarks are the property of their respective owners. Contents are subject to change. Printed in the U.S.A. Information in this document is subject to change and does not represent a commitment on the part of TransCore, LP.
For further information, contact:

TransCore

8600 Jefferson Street NE Albuquerque, New Mexico 87113 USA

TransCore Technical Support

Web: www.transcore.com Phone: 505-856-8007

FCC Statment

WARNING TO USERS IN THE UNITED STATES
FEDERAL COMMUNICATIONS COMMISSION (FCC) LOCATION AND MONITORING SERVICE STATEMENT 47 CFR §90.351

NOTE: The user is required to obtain a Part 90 site license from the Federal Communications Commission (FCC) to operate this radio frequency identification (RFID) device in the United States. The FCC ID number is FIHE4PT90V45. Access the FCC website at www.fcc.gov to obtain additional information concerning licensing requirements.
NOTE: Users in all countries should check with the appropriate local authorities for licensing requirements.

FCC RADIO FREQUENCY INTERFERENCE STATEMENT 47 CFR §15.105(A)

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate RF energy and may cause harmful interference to radio communications if not installed and used in accordance with the instruction manual. Operating this equipment in a residential area is likely to cause harmful interference, in which case, depending on the laws in effect, the user may be required to correct the interference at their own expense.

NO UNAUTHORIZED MODIFICATIONS 47 CFR §15.21
CAUTION: This equipment may not be modified, altered, or changed in any way without permission. Unauthorized modification may void the equipment authorization from the FCC and will void the warranty. USE OF SHIELDED CABLES AND GROUNDING 47 CFR §15.27(A)

NOTE: Shielded cables and earth grounding the unit is recommended for this equipment to comply with FCC regulations.