ANXONIT Cylinder X2 Portable Smart Mini DLP Projector Instructions
- June 6, 2024
- ANXONIT
Table of Contents
Cylinder X2 Portable Smart Mini DLP Projector
INSTRUCTIONS
Product performance
Model No.: Cylinder X2/X2 Pro
Power: 5V-2A(please use only the default
power come with the projector in box)
Working Temperature: 0°C~ +40°C
Accessories List
Following list for reference,
please take which you received as final
Product View
View for product understanding, product appearance shall prevail
Adjust the focal length
Turn on the projector,
slowly turn the focus ring until the projected picture clear.
PS: The best projection distance is 0.3m~3m_
Turn on/Turn off
Turn on: When projector is off, press and hold power
key for 3 seconds to turn on the unit.
Turn off: When projector is on, press and hold the power
key on remoter or unit for 3 seconds to turn off the unit.
Factory Reset: setting ~ system setting- factory reset
Forced shutdown: When projector is on,
press and hold the power key for 10 seconds,
the unit will be shutdown forced.
Network setup
For the first using, choose “Setting” – “Network Setup”
— wife choose the network you want to connect.
Remoter
Keystroke
Power—Press and hold for 3 seconds to turn off the unit
Flying Mouse — Switch the selection cursor
Setting – System function setting
MUTE — Turn on / off the volume
Arrow Keys (R/L)—move the cursor as you need,
hold the arrow keys to make fast forward or rewind
the video when playing,
OK – Confirm the current choice
HOME – Back to the main interface
Return —Back to the last page / interface
Menu – Press and hold to view the operation menu
Volume — Adjust the volume
Page up / down —Go to the last / next page
Charging
Please use only the default adapter and cable for the unit
charging. When the unit is off, the top illustration light will
be twinkling while charging, and it will cost around 4 hours
I full charged. And the timing will be longer when charging
while projector under working.
More operation help please go to User Guide Thank you!
Thank you!
@2019-2021 Anxonit Inc all right reserved.the Anxonit® logo
and associated characters,trademarks and design elements
are owned and licensed by Anxonit company.
www.anxonit.com
FCC WARNING This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment. NOTE: This equipment
has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures: — Reorient or relocate the receiving antenna. — Increase
the separation between the equipment and receiver. — Connect the equipment
into an outlet on a circuit different
from that to which the receiver is connected. — Consult the dealer or an
experienced radio/TV technician for help. To maintain compliance with FCC’s RF
Exposure guidelines, This equipment should be installed and operated with
minimum distance between 20cm the radiator your body: Use only the supplied
antenna.