MAGTEC 21079837 Magnet Smart Card Reader Installation Guide
- June 6, 2024
- MAGTEC
Table of Contents
tDynamo GenⅡ
Model: 21079837
Manual
December 2019
Version 001
Installation Guide
-
tDynamo Gen Ⅱ has two parts.
-
tDynamo Gen Ⅱ can be used alone, also can be used on the support .
Operation Guide
There are three kinds of usage
-
First, press the button after using Bluetooth link equipment.
-
Second, on the card reader Connect the USB type – C interface, the other end is inserted into the host with USB interface, and then turn on power supply.
-
Third, put the reader into the base, with the base USB inserted into the host. Turn on power supply.
To use a MSR card
Swipe card, make sure the MSR is on the bottom side, press the card to the
bottom of the slot and swipe.
To use an IC card
Make sure the IC contacts are on the top side. Insert the card to the end of
the slot.
To use a NFC card
Place the card near the NFC symbol on the case.
Transactions Guide
Refer to the guide of the software.
FCC Compliance
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. The distance between user and device should be no less than 20cm.
This product can be used across EU member states.
We declares that this device is in compliance with the essential requirements
and other relevant provisions of Directive 2014/53/EU.
RF Specification
Bluetooth
Operation Frequency:| 2402〜2480MHz
Maximum Power(V4.0):| 5.34 dBm
|
NFC|
Operation Frequency:| 13.56MHz
Maximum Power:| 38.80 dBuA/m@3m
Manufacturer: Magtek Incorporated
Address of Manufacturer: 1710 Apollo Court, Seal Beach, California 90740,
United States temperature of the device between 0°C to 40°C. The operating
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.