One Six Eight PT1255 Outdoor Trolley Speaker Instruction Manual
- June 6, 2024
- One Six Eight
Table of Contents
INSTRUCTION MANUAL
Important Safety Measure
When you go out
- Pull its plug out of socket even if the play that is still connected to AC power supply is in the state of a stop.
To prevent humidity, water, and dust
- Don’t put this player in a place with high humidity or much dust. A vase or other object with water should not be put over this player
To prevent high temperature
- Don’t expose this player to sun or put it near heat-sending equipment.
To protect the surface of this player
- Don’t spray insecticide Cs-elTh near this player. Also, don’t use gasoline or banana water, or another solvent to clean because this kind of solution will cause discoloring to the surface of this player. Use a soft cloth to get rid of dust. For a chemical detergent, please use it according to its instructions.
Don’t dismantle this player
- It is dangerous to open the top cover and the back of this player or put hands into the player. Don’t dismantle this player. In case of a malfunction, pull the plug out of the socket immediately and contact your distributor or ask a professional for help.
To remove plug
- Pull the plug out of the socket instead of grasping the cable.
Using Battery
- Do not mix old and new batteries
- Do not mix alkaline, standard (carbon-zinc), or rechargeable (NiCad, Nimh, etc) batteries
Using the Radio
-
Turn on the unit.
-
Press Mode selector, set to Bluetooth®/ USB / AUX / FM.
-
Bluetooth®/ connectivity.
-
When you use the radio for the first time, press the button on
the control panel once, the unit will auto search and store for radio stations, then you can use PREV /NEXT to choose the stored radio stations. -
You can also use the PREV / NEXT buttons manual search for radio stations.
NOTES: FM reception may be different in locations, for better reception quality, please use henna and keep far from any electronic products to avoid affecting the reception.
Using the Wireless Microph
- Turn on the unit.
- Adjust the microphone volume by turning the MIC VOL/ECHO knobs located at the rear panel of the unit.
NOTES: you can use the wired microphone and wireless microphone at the same time. Wired microphone was not included in the product package.
The Function Silk-printed on the Iron Plate
- BASS: Bass adjustment
- TREBLE: Treble adjustment
- TF CARD port
- USB port
- Volume: Adjust the master volume knob to change the volume
- Use 3.5mm input, connect mobile phone or computer
MODE
Mode: Bluetooth®/USB/FM/AUX- PREV: Short press the switch to the last song, long press to lower the volume, FM CH-
- Audio play/pause/FM scan
- NEXT: Short press the switch to the next song, long press to increase the volume, FM CH+
- REC mode (Available when a USB drive is pluged-in only)
- ECHO: Microphone reverberation adjustment
- MIC.Volume: Microphone volume adjustment
- Charge parameters: Use DC15V charger
- Charging indicator light
- MIC.IN: Use 6.5mm preferred MIC and guitar
- Use the battery of the 12V input
- Turn on the switch, power on
- LED switch
Remote Control Function
: The machine works in any state and press this button, the system enters
standby mode.
MODE: Press it to switch to different modes, such as radio, Bluetooth,
USB, TF card etc. 0-9numberkey: Digital input keys for direct selection of
tracks .
EQ: In music mode, you can switch to a different sound.
MUTE: In playback mode used the sound off and on.
REP: Track Repeat key to select single repeat and all track Play/Record
STOP: Suspended
: In music mode, can switch to last song; In radio mode, can be switch to last
channel.
: Press once to pause playback During playback, press again to continue
playing.
****: In music mode, can switch to the next song; Radio mode can switch to
the next channel.
VOL-: Volume down key.
VOL+: Volume up key.
Remote Control Battery Installation
At the bottom of the remote control has a transparent insulating slice, for
initial use, please pull out the insulation sheet
Replace the remote control batteries
When the remote control is near the host and no remote control, please replace
the battery.
The range of remote control
The effective distance of the remote control-based machine before more than 8
meters, angle of 60 degrees or less; the remote control distance will be
changed with environmental brightness and the presence of obstacles changing.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>