Clarke CWVE1 Vacuum Extractor Instruction Manual
- June 6, 2024
- Clarke
Table of Contents
Clarke CWVE1 Vacuum Extractor Instruction Manual
INTRODUCTION
Thank you for purchasing this CLARKE Workshop Vacuum Extractor.
Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service.
PRODUCT SPECIFICATIONS
GENERAL SAFETY PRECAUTIONS
WORK AREA AND PERSONAL SAFETY
- Avoid operating in the presence of flammable liquids or gases. The motor may produce sparks during operation. Do not use in enclosed areas where flammable, explosive or toxic vapours are given off.
- Always stay alert, watch what you are doing and use common sense when operating the dust extractor. Do not use while you are tire or under the influence of medication, drugs or alcohol. Lack of attention can result in personal injury.
- Never over-reach. Keep your proper footing and balance at all times to enable better control of the dust extractor in unexpected situations.
- Never use a power product if any part is damaged. Have it inspected and repaired by your Clarke dealer. Do not use if the electric cable, plug, or the machine itself, is in poor condition.
- Do not insert fingers or other objects into the inlet opening.
- Always wear eye and ear protection when using the extractor.
GENERAL PRODUCT USE AND CARE
- Prior to use, all users should become familiar with the warnings in this instruction manual.
- Always maintain the dust extractor with care and keep it clean for best/ safest performance.
- Never abuse the power cable. Never pull on the cable when removing the plug from the socket or lift the extractor by the power cable. Take care not to close doors on the cable or allow it to become snagged under objects with sharp edges. Keep away from heat or oil.
- Only use extension leads that are of an appropriate power rating and suitable for the work environment. Extension leads must have an earth connection. Inspect the extension lead regularly and replace if damaged.
- Never abuse the dust extractor by standing on it.
- Always store the dust extractor out of reach of children.
DUST EXTRACTOR SAFETY INSTRUCTIONS
- This dust extractor is for indoor use only.
- This dust extractor is for collecting wood chips, shavings and dust particles only. Do not use with hazardous substances i.e. MDF dust.
- Always ensure that the dust extractor is properly positioned where necessary to prevent it from moving during use and that the immediate area is kept clear.
- Always use a face or dust mask if operation is particularly dusty including when disposing of the contents.
- Always disconnect the dust extractor from the power supply before servicing or removing & emptying the filter bag etc.
- Never leave the dust extractor running unattended. Turn power off and wait for the machine to stop before leaving.
- Do not use in enclosed areas where flammable, explosive or toxic vapours are given off, by oil based paints, paint thinner, petrol etc.
- Never pick up flammable or readily combustible material, including burning cigarettes or other smoking substances.
- Never attempt to pick up liquids with this vacuum extractor.
- Always use in an upright position. Always transport the dust extractor using the handle.
- Always take care when a long hose is required in the work area as it presents a trip hazard. Tidy the hose away when the job is finished.
- Do not use without the inlet hose attached and ensure the cover is securely in place when in operation.
- Only use parts and accessories recommended in this manual. The use of unauthorized accessories or attachments is not permitted and may result in personal injury or damage to the dust extractor.
- Do not attempt to repair or modify the dust extractor or attempt any electrical repair yourself. Consult a qualified electrician or the Clarke Service Department on 020 8988 7400.
SAFETY SYMBOLS
The above safety symbols appear on the product.
ELECTRICAL CONNECTIONS
WARNING! READ THESE ELECTRICAL SAFETY INSTRUCTIONS THOROUGHLY BEFORE CONNECTING THE PRODUCT TO THE MAINS SUPPLY.
Before switching the product on, make sure that the voltage of your electricity supply is the same as that indicated on the rating plate. This product is designed to operate on 230VAC 50Hz. Connecting it to any other power source may cause damage.
This product may be fitted with a non-rewireable plug. If it is necessary to change the fuse in the plug, the fuse cover must be refitted. If the fuse cover becomes lost or damaged, the plug must not be used until a suitable replacement is obtained.
If the plug has to be changed because it is not suitable for your socket, or due to damage, it should be cut off and a replacement fitted, following the wiring instructions shown below. The old plug must be disposed of safely, as insertion into a mains socket could cause an electrical hazard.
WARNING! THE WIRES IN THE POWER CABLE OF THIS PRODUCT
ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE:
BLUE = NEUTRAL BROWN = LIVE YELLOW AND GREEN = EARTH
If the colours of the wires in the power cable of this product do not correspond with the markings on the terminals of your plug, proceed as follows.
- The Blue wire must be connected to the terminal marked N or coloured black.
- The Brown wire must be connected to the terminal marked L. or coloured red
- The Yellow and Green wire must be connected to the terminal marked E or or coloured Green.
We strongly recommend that this machine is connected to the mains supply via a Residual Current Device (RCD). If in any doubt, consult a qualified electrician. DO NOT attempt any repairs yourself.
COMPONENTS
ASSEMBLY
OPERATING AND MAINTENANCE
Regularly inspect the filter for damage before use and replace if necessary.
Regularly check the tightness of the filter, filter bag and retaining band.
Check the power cable to ensure it is free from cracks, bare wires etc.
Connect the inlet hose to the outlet on your woodworking appliance using the
inlet adaptor(s). Start the extractor using the ON/OFF switch (I=on/O=off).
Take care not to suck in foreign objects such as screws, nails, large pieces
of plastic or wood.
Empty the dust extractor after use and clean it when required. Dislodge as
much imbedded debris as possible from the filter. Refit the filter over the
motor inlet.
Ensure the hose is kept in good condition. A damaged hose will seriously
effect the efficiency of the dust extractor and should be replaced. Contact
your CLARKE dealer for replacements.
CARE & STORAGE
- When not in use, switch off and unplug from the power supply and ensure the power cable is not left as a hazard for persons to trip over.
- With the dust extractor unplugged from the power supply, use a dry cloth to wipe over the casing. Do not use solvents, thinners or alcohol to clean the dust extractor, as these chemicals will damage the finish.
- Store the dust extractor in a secure, dry place, out of the reach of children.
DO NOT leave it exposed to the elements and avoid direct sunlight, direct heat, rain/moisture etc.
TROUBLESHOOTING
ENVIRONMENTAL RECYCLING POLICY
Through purchase of this product, the customer is taking on the obligation to deal with the WEEE in accordance with the WEEE regulations in relation to the treatment, recycling & recovery and environmentally sound disposal of the WEEE.
In effect, this means that this product must not be disposed of with general household waste. It must be disposed of according to the laws governing Waste Electrical and Electronic Equipment (WEEE) at a recognized disposal facility.
GUARANTEE
This product is guaranteed against faulty manufacture for a period of 12 months from the date of purchase. Please keep your receipt which will be required as proof of purchase.
This guarantee is invalid if the product is found to have been abused or tampered with in any way, or not used for the purpose for which it was intended.
Faulty goods should be returned to their place of purchase, no product can be returned to us without prior permission. This guarantee does not effect your statutory rights.
PARTS DIAGRAM
DECLARATION OF CONFORMITY
parts@clarkeinternational.com
service@clarkeinternational.com
www.clarkeinternational.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>