Marvel Technology MWE360 360 Photobooth User Guide
- June 6, 2024
- Marvel Technology
Table of Contents
Marvel Technology MWE360 360 Photobooth
Attention
- Before using, please check whether the power cord, base LED Strip cord and other items are stuck on the rotating table or not, to prevent the cables from being damaged.
- For users safety, don’t jump hard on the Stage.
- Don’t make the edge of the Stage bear too much weight, better distribute the weight evenly on the stage.
- The Stage should be adjusted paralleled to the ground by rotating the foot cup before using.
- Do not stop the rotating rod deliberately when it was running.
- Do not put heavy objects on the Angle Adjuster and Selfie Telescopic Rod.
- Children should not use it alone, but must be accompanied by an adult.
Component Introduction
The attachments received are subject to as following
installation Guide
Step1: Take the Stage out of the package and adjust it parallel to the
ground with the Foot Cups. Then connect the AC-DC adapter to the control box
.
Step 2: Install the Angle Adjuster, and lock it with Fixed Screw
.
Step 3: Install the Selfie Telescopic Rod.
Step 4: Stick the LED Strip to the base and connect it to 5V Adapter (for LED Strip).
Step 5: Install Ring Light.
Step 6: Install Fixed Bracket and Phone Holders.
Step 7: Power bank, lithium battery connection and usage(Power Bank and lithium battery are not our standard accessories). The Ring Light should connect with USB port of the power bank. The motor controller should connect with the lithium battery s DC 24V power port. And the LED strip should con- nect with the lithium battery s DC 5V USB port.
Operation Instructions
- Install suitable batteries for all remote controls(CR-2032).
- Power up the AC-DC adapter.
- Plug the two USB(Ring Light& LED Strip) into the power bank and 5V adapter.
- Remote Control Instructions
Lightband Controller Instructions
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly
approved by the party.
Responsible for compliance could void the user’s authority to operate this
equipment. (Example- use only shielded interface cables when connecting to
computer or peripheral devices). This equipment complies with Part 15 of the
FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference
- This device must accept any interference received, including interference that may cause undesired operation.
RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.