DYNAUDIO BM5 mkIII 7 Inch Tow Way Active Studio User Manual

June 6, 2024
DYNAUDIO

BM5 mkIII User manual

Setup and Operation
Overview-rear panel

Correct setup and connections is essential to achieve optimal performance from your monitors. Please follow
Power On/Off switch
AC Power Input
Balanced analog input (XLR)
Unbalanced analog input (RCA)
Power Mode switch
Remote
Filter switches
High Pass
LF – Low filter setting

Setting up

1/2. Power on/off switch / AC power in
Before switching on, make sure Mains Voltage matches your area’s mains voltage specification.
3. Balanced analog input

Audio Input is via a female XLR connector. The input is electronically balanced with the following connection

  1. Unbalanced analog input (RCA)
    Unbalanced Input via RCA. If your audio source doesn’t have a balanced output, use the RCA input connection
    For best results always use an only good quality screened cables and connectors.
    Switches
    On the rear of the monitor, you will find six switches for setting up the monitor for optimum performance in de
    5. Power mode switch
    ON: The speaker is active and ready to play.
    ON/SLEEP: After if no input signal has been present on the input for 20 minutes the speaker enters the “Sleep
    6. Remote
    Usually, active speakers are at a max level all the time. By connecting the Dynaudio External Volume control,
    7. Filter switches
    LF
    This switch controls the bass gain level using shelf-type EQ. The level can be set to +2 dB, 0 dB or -2 dB.
    This filter is used to adjust for the proximity of boundaries, so if positioned close to a wall or corner, use the -2
    MF
    This switch sets a notch filter, used to compensate for the acoustic effect of a console.
    HF
    This switch controls the Treble level and it is used to match the high end of the monitor to your other electr
    HP
    This switch sets the lower cut-off frequency of the monitor. It is used to match the monitor to a subwoofer.
    8. Level trim
    Use this switch to match the sensitivity of the BM5 mkIII monitor to your source.
    High-output Source
    If your source has a high output, set switch to the -10 position to reduce sensitivity by 10 dB.
    Low-output source
    If your source has a low output, set switch to the +4 position to gain 4 dB more sensitivity.
    Protection
    The BM5 mkIII monitor has several built-in protection systems to reduce the risk of hazard or damage due
    Both power amplifiers have thermal protection. This activates if a problem should occur, and helps protect
    The woofer channel has a built-in limiter that protects the woofer unit from too much excursion. It works by
    Positioning
    The BM5 mkIII is designed as a precision near-field monitor and can be equally well used in both stereo an
    It can be placed on stands or on the meter bridge of a console provided that the meter bridge is sufficiently s

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals