Shenzhen Sperll Optoelectronic Technology SP108E WiFIi LED Controller Instruction Manual
- June 6, 2024
- Shenzhen Sperll Optoelectronic Technology
Table of Contents
**Shenzhen Sperll Optoelectronic Technology SP108E WiFIi LED
Controller**
Features
- Long distance APP remote control via WIFI;
- Support routing mode(AP) and LAN connection mode(STA);
- Support almost every kind of one-wire or two-wires LED driver IC ;
- Brightness adjustable, With 180 kinds of patterns and 8 kinds of color adjustable patterns;
- Creatively using from-image-to-effect method for user to DIY any effect;
- Support setting pixel number and segments number, able to control up to 2048 pixels;
- DC5V~24V wide range working voltage, reverse power supply input protection;
- User setting saving;
App control
Both IOS version and Android OS version are available. (hardware should support WIFI)
- Requires IOS version 10.0 or later;
- Requires Android OS version 4.4 or later;
- Search”LedShop”in App Store or Google pay or scan this QR code to download and install the App:
Specifications
- Working temperature: -20℃~60℃;
- Working Voltage: DC5V~24V;
- Working Current: 20mA~130mA;
- Remote distance: 30 Meters;
- Product size: 85mm45mm22mm;
- Product weight: 40g ;
- Certificates: CE, RoHS;
Working Mode and Connecting
- AP(Access Point) mode: Controller and Phone connect directly, controller works as an access point.
Connect steps:
- When the device is not connected to any WIFI network, power on the controller and wait for 20s and then controller will switch into AP mode ;
- In the WIFI setting page,find and connect the controller(named like SP108E_xxx, the default pin code is 12345678),
- Open the LED Shop App ,then the controller will be showed on the device list;
- STA(Station) mode: Controller and phone are in one same WIFI network, in this network, users can operate the controller smoothly.
Connect steps:
- When the device is not connected to any WIFI network,power on the controller, controller will be remain in Wait-For-Connet mode for 20 seconds;
- Make sure that your phone is connected to a WIFI network, Open LED Shop APP, pressing the Add Device button, input the WIFI pin code, then press the OK to confirm and wait for the configure processing finish;
- When controller successfully enter the WIFI network, it will be showed on the device list;
- User can select the controller and remove it out of the network by pressing the Remove Device button, then the controller will switch into AP mode.
Wire Connection
Documents / Resources
|
Shenzhen Sperll Optoelectronic Technology SP108E WiFIi LED
Controller
[pdf] Instruction Manual
SP108E, 2ATV8SP108E, SP108E WiFIi LED Controller, WiFIi LED Controller
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>