Ring 5AT2S8 Range Extender User Guide
- June 6, 2024
- Ring
Table of Contents
5AT2S8 Range Extender
User Guide
Let’s get started.
Quick Start Guide
In-app Setup
- Make sure your Alarm is disarmed.
- In the app, tap Set Up a Device and find the Range Extender in the Security Devices menu.
- Follow the in-app instructions to complete the setup.
Installation
- Make sure the Range Extender is plugged into an outlet at all times.
- Choose an outlet between your Base Station and some of the devices farthest from your Base Station.
You can move the Range Extender to another outlet as needed to expand the range of your Z-Wave network.
IMPORTANT PRODUCT INFORMATION
Safety and Compliance Information Use Responsibly. Read all instructions and safety information at before use.
SAFETY INFORMATION
FAILURE TOFOLLOW THESE SAFETY INSTRUCTIONS COULD RESULT IN FIRE, ELECTRIC
SHOCK, OR OTHER INJURY OR DAMAGE.
Range Extender is for indoor use only. Do not expose your device to liquids.
If your device or adapter gets wet, carefully unplug the device without
getting your hands wet and wait for the device to dry completely before
plugging it in again. Do not attempt to dry your device with an external heat
source, such as a microwave oven or a hairdryer. If the device appears
damaged, discontinue use immediately. To avoid the risk of electric shock, do
not touch your device during a lightning storm.
WATCH FOR SMALL PARTS. Your device and accessories may present a choking
hazard to small children. Keep them out of reach of small children.
WARNING: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment. This equipment should be installed and operated with a
minimum distance 20 cm between the radiator & your body.
CAUTION: To reduce the risk of electrical shock, DO NOT open the unit.
There are no user-serviceable parts inside the unit. Refer to customer support
for any repairs.
PRODUCT SPECIFICATIONS
Electrical Rating: 100-240V-50/60Hz40mA
Temperature Rating: 32°F to 104°F (0°C to 40″C)
Fuse Rating: 1/l.WS,100,component 1D-F1, F2
RECYCLING YOUR DEVICE PROPERLY
In some areas, the disposal of certain electronic devices is regulated.
Make sure you dispose of or recycle, your device In accordance with your local
laws and regulations. For Information about receding your device, go to
www.amazon.com/devicesupport
TERMS OF SERVICE AND WARRANTY
Use of the product is subject to your registration with Ring and your
agreement with the Terms of Service found at www.ring.com/terms.To review your
warranty coverage, please refer to the enclosure inside this box or visit
WWW.ring.com/warranty.
FOR USERS IN THE UNITED STATES
supplier’s Declaration of Conformity -Compliance Information Statement
Unique Identifier: Range Extender
Model: SAT258
FCC ID: 2AEUP5AT2S8
Re!ipOnsibleParty party issuing Supplier’s Declaration of Conformity:
Ring LLC,1523 26th Street Santa Monica, CA 90404
www.ring.com/legal@ring.com
FCC Compliance Statement (for products subject toPart15)
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and if not installed and u in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment to a socket on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Pursuant to Section 1521 of the FCC rules, changes or modifications to a
Product by the user that are not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment. The
device meets the FCC Radio Frequency Emission Guidelines. Information on the
product is on file with the FCC and can be found by inputting such Product’s
FCC ID (which can be found on the device) into the FCC ID Search form
available at https://www.fcc.gov/oettea/fccid. The party responsible for FCC
compliance is Ring LLC, 1523 26th Street Santa Monica, CA 90404.
FCC Radiation Exposure Statement
This device complies with FCC radiation exposure limits set forth for an
uncontrolled environment and it also complies with Part 15 of the FCC RF
Rules. This equipment must be installed and operated in accordance with
provided instructions and the antenna(s) used for this transmitter must be
installed to provide a separation distance of at least 20 cm from all persons
and must not be co-located or operating in conjunction with any other antenna
or transmitter. End-users and installers must be provided with antenna
installation instructions and consider removing the no-collocation statement.
FOR USERS IN CANADA
Innovation, Science and Economic Development Canada (ISED) Compliance This
device contains license-exempt transmitter(s)/ receiver(s) that comply with
Innovation, Science and Economic Development Canada’s license-exempt RSS(s).
Operation is subject to the following two conditions: 1. This device may not
cause interference. 2. This device must accept any interference, including
interference that may cause undesired operation of the device.
Information Regarding Exposure to Radio Frequency Energy This equipment
complies with IC RSS-102
RF exposure limits are set forth for an uncontrolled environment. This
equipment should be installed and operated with a minimum distance of 20 cm
between the radiator and your body.
©2020 Ring LLC or its affiliates.
Ring, Always Home, and all related logos are trademarks of Ring LLC or its
affiliates.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>