Pisen Electronics TP-C74 Qi2 Magnetic Desktop Charging Base Owner’s Manual
- September 5, 2024
- Pisen Electronics
Table of Contents
Pisen Electronics TP-C74 Qi2 Magnetic Desktop Charging Base
Product Information
Specifications:
- Model: XYZ123
- Power: 1200W
- Capacity: 1.5 liters
- Material: Stainless steel
- Dimensions: 10 x 12 x 8 inches
Product Usage Instructions
Initial Setup:
Before first use, ensure all parts are clean. Place the kettle on a flat,
stable surface near a power outlet.
Filling the Kettle:
Open the lid and pour water into the kettle up to the desired level
indicated inside. Do not exceed the maximum capacity.
Heating:
Plug in the kettle and press the power button. The kettle will start
heating the water. The auto-shutoff feature will turn off the kettle once the
water reaches boiling point.
Pouring and Serving:
Once the water is heated, carefully pour it out using the spout. Serve hot beverages immediately.
Cleaning and Maintenance:
Unplug the kettle and allow it to cool before cleaning. Wipe the exterior
with a damp cloth and descale regularly according to the user manual.
Frequently Asked Questions (FAQ):
-
Q: Can I heat liquids other than water in the kettle?
A: It is recommended to only heat water in the kettle to avoid damage or affecting the taste of other liquids. -
Q: How often should I descale the kettle?
A: Depending on your usage and water hardness, descale the kettle every 1-2 months to maintain optimal performance.
Specification
- Model OJD-Q203
- Input 9V/2.22A
- Output 5W/7.5W/15W
- Interface Туре-с
- Conversion rate > 73%
- Colour White /Black
DIMENSION
Note
- Please do not disassemble the product at will.
- Please do not use this product in high-temperature, damp environments.
- To charging contact surface on the back of the mobile phone cannot carry metal materials such as iron sheets, finger rings, metal protective shells, etc.
Packaging List
- Q12 Magnetic Wireless Charger*1
- User Manual*1
Product Appearance
Charging no working indicator light
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1)This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note : This equipment has been tested and found to comply with the limits
for a Class B digital device, under part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used by the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The FCC certification of this device refers to RF exposure testing performed
in typical operating conditions, where a person is no closer than 20
centimeters from the device surface at all times, except for non-repetitive
patterns with transient time intervals in the order of a second. Only in the
stated conditions, the device is shown to fully comply with the FCC RF
Exposure requirements of KDB 447498.
Made in China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>