LG ETPFFRPP01 4PPoE WLAN Bridge Installation Guide

LG ETPFFRPP01 4PPoE WLAN Bridge

Appearance Description for PoE WLAN Bridge

Front/Right side Panel

• The Right side panel has the 2-Button and Front panel has status LEDs in the following figure.

Left side/Back/bottom Panel & Label Information

• The back panel have product label and power plug, left panel has the wireless antenna, bottom plug and 1 x RJ45 ports.
• The label on the bottom shows the MAC address, serial Number.

Installation Guide

PoE Connection with AP

1. You can connect to AP by cellular phone
2. Insert PoE WLAN Bridge to AC Power. PoE WLAN Bridge is AP mode at first.
3. Turn on the WLAN in your cellular phone and search AP List.
4. Select SSID ADC_Bridge_xxx. The xxx is Mac Address final three numbers(e2b in below picture). You can check in Label
5. Open internet explorer and input any URL address. If you insert every URL, you connect PoE WLAN Bridge wep page.
6. Please select language. Now PoE WLAN Bridge support three language.
7. Please click scan for WLAN Networks. If you use hidden SSID, input the SSID by yourself.
8. You can see the AP List and signal strength(RSSI). Click AP SSID which is used in your test.
9. Click the connect message.
10. You will see the wait message
11.  If you finish the process, your cellular phone disconnects from PoE WLAN Bridge.
12.  PoE Will reboot. After a few seconds, WLAN LED will be red. The red means that PoE WLAN Bridge is connecting with AP If WLAN LED is blinking Blue, AP connection is end.
13. PoE Connection with Power Device(Camera)
14. After AP connection, You can connect PoE WLAN Bridge and Power Device(Camera) by Ethernet Cable
15. Make sure that your camera is connected to the WLAN Bridge CAMERA port with an Ethernet cable(wired)

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Supplier’s Declaration of Conformity: 47 CFR § 2.1077 Compliance Information
Responsible Party: LG Innotek USA Inc.
Street Address: 2540 N 1st ST STE 400 SAN JOSE, CA 95131-1016 PHONE : +1-408-350-7661 / FAX : +1-408-955-0329

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>