VOLLRATH Instacut 5.1 Blade Replacement Instruction Manual
- June 6, 2024
- VOLLRATH
Table of Contents
Installation Instructions
Institut TM 5.1 Blade Replacement
A Base Assembly
B Bumpers
C Guide Rods
D Thumbscrew
E T-Handle
F T-Handle Assembly. Consists of the pusher head, cleaning tool and
the pusher block.
G Cleaning Tool. (Dicer and slicer blade packs only.)
H Pusher Block. Pushes the food product through the blade assembly.
Must match the slice, dice, core, or wedge size of the blade assembly.
I Blade Assembly. Houses the blades, wedge, or corer. Must match the
slice, dice, core, or wedge size of the pusher head block.
|
WARNING
---|---
Sharp Blade Hazard
Blades are sharp and can cause cuts. To avoid injury from sharp blades, handle
with caution.
INSTALLATION PROCEDURES
-
Wash the blade assembly with warm, soapy water. Rinse thoroughly to remove the thin protective oil film.
-
Slide the T-handle assembly off the guide rods.
-
Raise the bumpers approximately 2″ (5.0 cm).
-
Remove the old blade assembly by loosening the thumbscrew and carefully pressing upward on the underside of the frame that surrounds the blades.
NOTICE: Do NOT touch the sharp underside of the blades. -
Install the new blade assembly by inserting the tab on the frame that surrounds the blades into the groove in the base. Then lower the blade assembly into a seated and flush position in the base. Tighten the thumbscrew.
-
Slide the bumpers down the guide rods so they rest on the base.
-
Position T-handle assembly onto the guide rods and slowly lower the assembly. Check the pusher head block to blade assembly alignment.
-
Lubricate the guide rod with mineral oil, Petrol-Gel, or another food-grade lubricant after each use.
NOTICE: Do NOT use cooking oil as it will become sticky and may permanently damage the equipment.
The Vollrath Company, L.L.C. Headquarters
1236 North 18th Street
Sheboygan, Wisconsin
53081-3201 USA
Main Tel: 800-624-2051 or
920-457-4851
Main Fax: 800-752-5620 or
920-459-6573
Canada Customer Service: 800-695-8560
Tech Services:
techservicereps@vollrathco.com
www.vollrath.com| Pujadas
Ctra. de Castanyet,
132 P.O. Box 121
17430 Santa Coloma de Farners
(Girona) – Spain
Tel. +34 972 84 32 01
info@pujadas.es| Vollrath of China
Vollrath Shanghai Trading Limited
Room 201, Building A
Xin Yi Plaza
1618 Yi Shan Road
Shanghai, 201103
China, P.R.C.
Tel: +86-21-5058-9580| Vollrath de Mexico S. de R.L. de C.V.
Periferico Sur No. 7980 Edificio 4-E
Col. Santa Maria Tequepexpan
45600 Tlaquepaque, Jalisco | Mexico
Tel: (52) 333-133-6767
Tel: (52) 333-133-6769
Fax: (52) 333-133-6768
---|---|---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>