Shenzhen Qikaixin Electronic Technology HW-103D Wireless Charging Desk Lamp User Manual
- June 6, 2024
- Shenzhen Qikaixin Electronic Technology
Table of Contents
HW-103D
WirelessChargingDeskLamp
UserManual
Introduction
HW103Dwirelesschargingdesklampisanintelligentproduct. Simply designed, it gives out great lights with different color temperatures. Also, it has a built-in wireless charger that is compatible with any Qi-standard phone and device. Besides, it is integrated with USB output function which makes charging much easier. Now enjoy a simple and
Outline
Wireless Charging Applicable Devices
- The built-in wireless charging receiving device (Samsung, Nokia, Apple, Huawei, LG, etc.)
- The equipment has a reserved wireless charging interface, and it is necessary to install the equipment with the protective sleeve of the receiving device (Note: these receiving devices must comply with wpcqi standard for compatible use)
How to Use
- Insert the type-C interface of the power adapter into the power input port of the desk lamp. (as shown in the figure below)
- After power on, you can use the desk lamp according to the function diagram of the keys on the previous page note that except that brightness plus and brightness minus are sliding operations, other keys are short press operations.
- When using the wireless charging function, place phones with Qi receiver onto the wireless charging area. At this time, the wireless charging indicator turns on and flickers to indicate that wireless charging works properly. The indicator turns off after the phone is removed.
Accessories
HW-103D Wireless Charging Desk
Lamp User Manual
Specifications
Input: 5V/3A 9V/2A 12V/1.5A
Desk Lamp Output: 5W
LED Qty: 48pcs 4014LED
CRI: 85max
Center Luminance: 1200lux
Color Temperature: 2800&3400&4500&5600K LED Longevity: 50000hrs
Wireless Charging Output: 10W
Transferring Distance: ≤5mm Efficiency≥76%
Size: L180mm x W130mm x H400mm
Weight: 490g
Notes
- In order to ensure the use effect, please be sure to use the power adapter and high-quality wire with an output of 5V/3A 9V/2A 12V/1.5A
- Please keep the charger and receiver away from water and other liquids.
- If you need to clean the charger, please make sure it is disconnected from the power supply.
- Keep the ambient temperature at 0 – 45 ℃
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. During the operation of the device, a distance of 15cm surrounding the device and 20 cm above the top surface of the device must be respected.