Shenzhenshi Shizhandeng Maoyiyouxiangongsi W6 Wireless Digital Microphone Instruction Manual

Shenzhenshi Shizhandeng Maoyiyouxiangongsi
W6 Wireless Digital Microphone
Instruction Manual

Transmitter Introduction–TX

1. ON/OFF button:
   Long press for 2 seconds–power on/off;
   Short press–power query (the white light of the battery icon in the middle will flash)

2. Mute key:
   Short press — Mute the microphone (and the microphone icon is always on in red)
   Press and hold for 8 seconds — enter pairing mode (connection icon indicator light flashes quickly)

3. Microphone

4. Indicator Light Description
   

5. USB-C charging port

6. TES External microphone interface

Receiver Introduction–RX

1. ON/OFF button:
   Long press for 2 seconds–power on/off;
   Short press–power query (the white light of the battery icon in the middle will flash)

2. Volume key:
   Short press–Volume output selection (high-medium-low), the default volume is medium each time it is turned on, and the corresponding different colors will flash twice at  the same time.
   Press and hold for 8 seconds — enter pairing mode (connection icon indicator light flashes quickly)

3. Headphone output port–monitoring headphone port

4. noise reduction button
   Short press–Turn on/off the noise reduction function (the receiver microphone indicator light will light yellow in working mode)

5. Indicator Light Description
   

6. USB-C charging port

7. TES External microphone interface

Technical Specifications

Application

Warm tips

1. External wired lavalier microphone can only use a 3.5mm TRS plug.
2. A 3.5mm TRS to TRRS audio cable is required for recording to a smartphone.
3. Pay attention to the distance between the wireless microphone and the mouth
4. The transmitter must be clamped well and cannot be rubbed against the clothing, otherwise, there will be low-frequency sound.
5. The transmitter should not be too close to the throat, otherwise, there will be too many low frequencies and the impact will be clear.
6. If your receiver is on the side of the stage, the transmitter should be worn on the left or right side of the body as much as possible, and the end with the most opportunities for the receiver, otherwise, the body will block part of the signal.
7. Using multiple wireless microphones at the same time may interfere with each other.
8. It is better to use a sponge windscreen than not to use it. Don’t try to save trouble.

FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the  user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>