IKEA 204.867.84 TRADFRI LED Bulb Instruction Manual
- June 6, 2024
- Ikea
Table of Contents
IKEA 204.867.84 TRADFRI LED Bulb
OVERVIEW
ADD LIGHT SOURCES TO YOUR STEERING DEVICE:
Before you can use your light source you’ll need to pair it with a steering device.
To add more light sources, just repeat the steps below:
- Make sure that your light source is installed and the main power switch is turned on.
- Hold the steering device close to the light source you want to add (no more than 5 cm away).
- Press and hold the pairing button for at least 10 seconds. A red light will shine steadily on the steering device. Your light source will begin to dim and finally flash one time to indicate that it has been successfully paired.
Up to 10 light sources can be paired with 1 steering device. Make sure to pair them one at a time. If the light sources are close to each other, disconnect those that have already been paired from the main power switch.
CAUTION:
DO NOT USE WITH STANDARD DIMMERS. Only use the control provided with or
specified by these instructions to control this bulb. This bulb will not
operate properly when connected to a standard
(incandescent) dimmer or dimming control. Only controllable by IKEA Smart
lighting products. The color temperature can be switched between 2200K (warm
glow), 2700K (warm white) and 4000K (cool white).
RESET YOUR DEVICE
Toggle the main switch 6 times.
TECHNICAL DATA:
- Operating frequency: 2405 – 2480 MHz
- Output power: 10 dBm
The crossed-out wheeled bin symbol indicates that the item should be disposed of separately from household waste. The item should be handed in for recycling in accordance with local environmental regulations for waste disposal. By separating a marked item from household waste, you will help reduce the volume of waste sent to incinerators or land-fill and minimize any potential negative impact on human health and the environment. For more information, please contact your IKEA store.
- Manufacturer: IKEA of Sweden AB
- Address: Box 702 SE-343 81 Älmhult SWEDEN