Minfu PRP-2 Wireless Microphone Instruction Manual
- June 6, 2024
- Minfu
Table of Contents
Minfu PRP-2 Wireless Microphone
There is a wireless microphone board in the supporting audio, which is
responsible for transmitting, and the wireless microphone is responsible for
receiving.
They have a fixed frequency, so the wireless microphone can work normally.
Microphone Parts
- Diaphragm: Speak Into the Diaphragm to transmit your voice to the PRP_2
- ON/MUTE/OFF Switch: Activate the microphone, mute, or micr6fono, silence tum OFF the mic using the switch.
- Battery Compartment: Twist to open and install 2 xAA batteries (batteries not included)
- Transmitter: Keep the transmitter pointed at the PRP-2 and cleared from obstacles for the best reception.
INSTRUCTION
-
For battery Installation, twist the battery compartment to the Left to open.
-
Install 2xAA batteries and make sure the +/- are installed correctly.
Follow the printed symbols on the mic. -
After installing the battery, close the compartment by turning it clockwise.
Please remove the batteries if its not being used for a long period of time to prevent damage.
FCC Information
This device complies with Part 15 of the FCC rules.Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received; including interference that may cause undesired operation.Federal Communications Commission (FCC) StatementThis Equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV/technician for help.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user authority to operate the equipment. Tested to comply with FCC standards. FOR HOME OR OFFICE USE.
Warning: This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna(s) must not be co-located or in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>