WEWO WI01 Ultra-Thin Mobile Phone Wireless Charger with Qi Universal Charging Transmitter User Manual
- June 6, 2024
- WEWO
Table of Contents
Product name: Wireless charger x6
Model: WI01
User Manual
Accessories:
Wireless transmitter x1
Type c-USB data cable x1
User manual x1
Note: Thank you for your acquisition of this ultra-slim, light, and
portable wireless transmitter, compatible with all Qi devices like Samsung
57/S7 edge, Samsung S8/58 edge, iPhone8, iPhone8 plus, iPhone X, etc.
For optimum performance and safety, please read this manual carefully
before using this product
Specifications:
Input : 5V/2A ; 9V/2A ;12V /1.67A
Wireless Output : 5V/1 A ; 9V/0.83A ; 9V/1.12A ; 9V /1.67A
Product Size: ∅100 x 7.4mm
Charging Efficiency: z 65%
Transmission Distance: < 6mm
① Input port
② LED indicator
③ Transmitter
How to Use
Charging your wireless transmitter
- Charge your wireless transmitter via included Type c-USB data cable. The red LED indicator will be on when plugged into a power adapter or charged with another power source.
- Make sure there is no clutter on the wireless transmitter.
- The wireless transmitter is ready for your mobile device.
Charging the mobile device from the wireless transmitter
- Put your mobile device (the phone you used must support wireless charging or your phone is equipped with a wireless receiver chip) on the wireless transmitter.
- When your mobile device is being charged, the Blue LED indicator will keep on.
- When your mobile device is fully charged, the Blue and Red indicator off.
- When the red LED or blue LED indicator flashes quickly, that means there is improper operation.
When your wireless transmitter working improperly
- Clean the clutters on the wireless transmitter.
- When the wireless transmitter is over-heating, take your mobile device away from your wireless transmitter. And the transmitter will stop charging automatically when over Please try charging again when the wireless transmitter cooling down.
Remarks
- The wattage of the power adapter you used to need more than 7.5W, We suggest you use the adapter with 5V/2A output.
- It’s normal that this charger and your smartphone will be hot under operating conditions, and it may be hotter when charging and using at the same time( such as looping music ).
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure: A distance of 15 cm shall be maintained between the antenna and users, and the transmitter may not be co-located with any other transmitter or antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>