MAGEASY GS-PS01 Portal 2 In 1 Magnetic Wireless Charging Stand User Manual
- October 27, 2023
- MAGEASY
Table of Contents
MAGEASY GS-PS01 Portal 2 In 1 Magnetic Wireless Charging Stand
PRODUCT DESCRIPTION
DESIGN CONCEPT
Life on Display. Beautiful from all angles and complementing any setting, the
timeless design and attention to detail make PORTAL an instant classic.
The unique 2-in-1 design with Mag Safe-compatible charging pad offers ultimate
convenience for charging anywhere, with premium quality materials and
construction for an unmatched charging experience.
PRODUCT SPECIFICATIONS
| Model : | GS-PS01 |
|---|---|
| Material : | PC+ ABS + Zinc Alloy + Silicone |
Technical :
a. Input :| 15W (5V⎓3A)
b. Output
(Wireless Charging) :| 5W
USER GUIDE
PORTAL Charging Stand
- Please use the USB-C cable included in the PORTAL package to ensure the best charging efficiency.
- Please use a DC of at least 5V/3A (15W) charger is recommended for best charging efficiency.
- Use the USB-C cable and plug in the USB-C port on bottom of charging stand and other side plug in the charger.
- After iPhone 12 series, its can perfectly aligned for magnetic wireless charging on power bank.
GENERAL PRECAUTIONS
- Please do not place any objects, such as coins, on top of the charger while charging.
- Please charge with a wireless charging compatible phone case or without phone case while charging.
- Within 2mm thickness phone case recommended.
- During use, if charging stops because the charging pads are overheating, remove device, wait for it to cool down before charging again.
- Please use a DC of at least 5V/3A (15W) charger is recommended for best charging efficiency
WARNINGS
- Do not pull on the power cord to avoid breakage or disconnect.
- Do not disassemble, throw into fire or submerge under water to avoid short circuit of electrocution.
- Do not use it in extreme temperature, damp or corrosive environments to avoid damage to the circuit and electrocution.
WARRANTY COVERAGE
The following conditions are not covered by the warranty:
- Accessories are not guaranteed.
- Failure caused by improper operation of the user shall not be guaranteed.
- Faults caused by unexpected disasters, man-made damage, self disassembly, unpacking and maintenance by maintenance centers not authorized by the company
Note: our company will not bear any responsibility for damage to mobile equipment or even danger caused by improper operation of users.
SAFETY AND CERTIFICATION
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm
between the radiator and your body.