FLOITTUY H8 Bluetooth Speaker Alarm Clock User Guide

H8 Bluetooth Speaker Alarm Clock
User Guide

SAFETY INFORMATION

• Please read and keep this User Guide, and pay attention to the below warnings.
• Please put this speaker alarm clock in a stable place, to avoid any damage caused by accident dropping.
• Please keep this speaker alarm clock away from any liquid or fire.
• Please don’t leave this speaker alarm clock in a high temperature, or high moist environment for a long time.
• Please don’t insolate this speaker alarm clock.
• The charging voltage is DC 5V. The speaker alarm clock’s internal chip will be burned out and couldn’t work normally if using the higher charger

PACKING LIST

• 1pcs Speaker Alarm Clock
• 1pcs Charging Cable
• 1pes Gift Bag
• 1pcs User Guide

OVERVIEW AND INSTRUCTIONS FOR USE

Function Introductions:

LED fight
Red LED: Lighting when charging, and light off when fully charged.
Blue LED: Flashing fast when searching BT signal or scan FM signal and long time lighting after Paired Flashing slow when BT/TF/Aux/FM working, and long time lighting when paused.

1. ( )Long press these two keys at the same time so you can turn off completely the speaker, including the speaker and clock.
2. There will be a little temperature deviation since the temperature sensor is built in.
3. The screen will go back to the darkest brightness after 20 minutes of any setup brightness, to save power.
4. When charging, the time is lit on if no BT signal to pair, and the unit power off within 2 hours automatic. When TF/Aux/FM mode, and to power off if paused within 30mins.

OPERATION INSTRUCTIONS

Clock/Alarm Setting Instructions:
Clock/Alarm and speaker are two independent modes.
Press ( ) for 3 seconds to turn off the speaker mode, short press ( ) once or twice again, to get into the clock/alarm mode for setup, and the numbers will start flashing.
Press ( ) to shift forward and backward in order to set the following: clock’s hours/minutes, AL1 hours/minutes/rings, AL2 hours/minutes/rings.
Press ( ) to adjust the value of the current setting: the clock’s hours/minutes, the alarm hours/minutes/rings, the type of the rings (6 rings available; see notes below), the ON/OFF of the rings.
Press ( ) to confirm each setup value, every time (time setting need to confirm, alarm setting needs to confirm). The settings will fail if they haven’t got confirmation.

Note:

1. There will be one or two ( ) displayed on the screen if the alarm is set up successfully. Otherwise, the alarm settings will fail.
2. Snooze: Press ( ) to end the alarm ring when it starts, press any other buttons to get into snooze status. The alarm will ring 5 times, 10 minutes interval each time in snooze status. The ring lasts about 1 minute each time.

Rings options: there are 5 built-in rings available and the TF card audio sources also could be used as alarm rings. The TF card has to be put into the speaker and the audio files from the TF card can be used. The rings will play the audio files in tums, as the speaker works in TF card mode. The alarm will play the first built-in ring if there is no card in the speaker, even if the TF card has been set as the ring source for the alarm.

Bluetooth Speaker Instruction

Two Modes Instruction:
This speaker is with Bluetooth Speaker Mode.
Bluetooth Speaker Mode: long press the ( ) button to turn on, the speaker is in the Bluetooth Speaker Mode at this status, Alarm can’t be set.
Clock/Alarm Setting Mode: long press the ( ) button to turn off the speaker and shift to clock/alarm mode, while the Bluetooth speaker is not functional. Short press ( ) again,  and the numbers will flash, and then the clock and alarm can be set up.
The speaker mode will be off automatically after 2 hours with Bluetooth detached or without any operations.

How to connect the mobile phone by Bluetooth?

1. Long press the ( ) button for 3 seconds to turn on the speaker, and the small BT icon will flash in the left-down corner of the screen.
2. Turn on the Bluetooth from the mobile phone and search H8, and then match the speaker to the mobile phone. There will be a prompt sound after the connection succeeded.
   (Note: There is a memory function for the Bluetooth speaker. Turn off the Bluetooth of the previous mobile phone before connecting the speaker to another one).
   Hands-free function: Short press the button to answer the phone call, long press the button ( ) to refuse the phone call. Press the ( ) button to finish the phone call.

How to Line-in by Aux (external audio input)?
This speaker can connect to all kinds of audio devices (such as mobile phones, pads, MP3 players, cassette players, CD players, radios, etc.). with a 3.5mm AUX plug in the earphone jack of the audio device and the other end in the AUX slot of the speaker, then press “M” button to get into Aux Mode.

How to use a Micro SD/TF Card?
Insert the Micro SD/TF Card into the TF slot of the speaker, there will be a prompt sound, and then play the audio files from the card, when the unit is under the TF card mode.
It supports following the following format file: MP3, WAV.
It supports a maximum of 32GB TF card.

How to use FM radio?
Press the M button to shift into FM mode, and insert the antenna to the Aux stot.
Long press the M button and the speaker will get into FM channels searching mode, automatically. When the led indicator will be on and blue, will flash quickly. The speaker will save and play the FM channels after the searching is done. (The radio effect depends on the circumstances and signal. Radio will be good with a strong signal when there is less interference, but will not be good with a weak signal when there is much interference).

How do charge?

1. The speaker will make a prompt sound and tum off automatically when the battery is low. Insert one end of the cable into the charging slot of the speaker, and the USB  plug into the computer or the mobile charger (5V 1A). The front indicator light on red indicates it’s charging; the front indicator light off indicates it’s fully charged. (If the charging voltage is over 5V, the speaker’s internal chip will be burned out).

It takes around 4 hours for the speaker to be fully charged. It could work about 8-10 hours at maximum volume, and 16 hours at default volume. The standby time is about 200  hours (with the darkest brightness).

Reset function:
When the buttons are out of control, the speaker may get stuck. Please check if the battery ran out. If the battery ran out, please charge it. If the stuck happens while the battery is full, please long press the Power button( )for 10 seconds to reset the speaker.
Using the speaker with a tablet, PC/Notebook:
Connect the speaker and tablet, PC/Notebook by using the 3.5mm AUX cable.

F&Q

1. It cannot be matched with the devices by Bluetooth: (1) turn off the speaker and mobile phone, and then turn on both. Rematch. (2) If there are too many Bluetooth devices around, turn off the other Bluetooth devices in order to connect to one device.
2. Sound is too small or distortion is too much: (1) Maybe the battery runs out. Please charge it. (2) Turn up the volume of the mobile phone.
   Sound goes off and on: please check if the range between the speaker and the device is more than 10 meters. Or check if there are any barriers between the speaker and the device.

DISPOSAL OF ELECTRICAL AND ELECTRONIC EQUIPMENT
This symbol on the product or packaging means that the product should not be treated as household waste. Do not throw garbage at the end of its life, but take it to a collection center for recycling. in this way you will help to protect the environment and be able to prevent any negative consequences that it would have on the environment and human health.
We hope you never have such a need, but if you do, our friendly and hassle- free service will work hard to put a smile back on your face. We hope that our after-sales service can make you satisfied.
Notice: As Amazon separates customer orders and product reviews, we CAN’T find your order 1D and email address depending on product reviews. Please contact us directly via the email below.

support@fabulouscool.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>