Shenzhen Sanwo Digital Technology LP-1801 Remote Controller User Manual
- June 6, 2024
- Shenzhen Sanwo Digital Technology
Table of Contents
LP-1801 Remote Controller
Wireless Remote Control Intelligent Turn Signal User Manual
1.Product Introduction
4.Installation Instruction 4GOQVG%QPVTQN2CKTKPI 6WTP5KIPCN+PUVCNNCVKQP
(KIWTG#
4GOQVG%QPVTQN(WPEVKQP
2.Product Appearance Schematic
1
1
2
2
3
3
5
4
4
3
2
5
1
3.Remote Control Appearance Schematic
2QYGT$WVVQP 4GF9CTPKPI.KIJV$WVVQP .GHV6WTP5KIPCN$WVVQP 4KIJV6WTP5KIPCN$WVVQP $TCMG.KIJV$WVVQP
4GOQVG%QPVTQN+PUVCNNCVKQP
5.Product Function Introduction 5YKVEJQPVJG6WTP5KIPCN
%QPUVCPVDTKIJV 4GOCKPKPIDCVVGT[ (NKEMGT 5VCPFD[
4GOCKPKPIDCVVGT[ 6JGTGF.’&YKNNHNKEMGTVKOGUCPFVJGP
VWTPQHHCPFVJGNGPIVJQHVJGTGFNKIJVDCTKU TGRTGUGPVKPIVJGTGOCKPKPIDCVVGT[
(KIWTG$ (KIWTG% (KIWTG&
6.Product Parameters
(KIWTG’ (KIWTG( (KIWTG)
7.Packing List
1 +PVGNNKIGPV6WTP5KIPCN 2 4GOQVG%QPVTQN 3 (KZGF5WRRQTVHQT6WTP5KIPCN 4
4WDDGT)CUMGV 5 /KETQ75$%JCTIKPI%CDNG 6 7UGT/CPWCN 7
(KZGF5ETGYCPF0WVHQT6WTP5KIPCN
/OO 8 5ETGYCPF0WVHQT4GOQVG%QPVTQN
/OO
8.Reminders:
6 1
2 4
5 7
3
8
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1)This device may not cause harmful interference.
(2)This device must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Note:This equipment has been tested and found to comply with the limits for a class B
digital device,pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequence energy and,if not
installed and used in accordance with the instructions,may cause harmful interference to
radio communications.However,there is no guarantee that interference will not accor in a
particular installation.if this equipmemt does cause harmful interference to radio or
television reception,which can be determined by turning the equipment off and on,the user
is encouraged to try to correct the interference by one or more of the following measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and receiver.
·
Connect the equipment into an autlet on a circuit different from that to which the
receiver is connectec.
· Consult the dealer or an experienced radio/TV technician for help.