Kimex 130-2102 Splitter Installation Guide
- October 27, 2023
- Kimex
Table of Contents
Kimex 130-2102 Splitter
INTRODUCTION
This high-performance HDMI2.0 splitter provides one HDMI into two HDMI outputs and supports 4K2K, Full 3D, 12-bit Deep Color as well as High Definition Lossless Audio. With its 18Gbps bandwidth and the additional features of the latest HDMI standards, you can be sure of great HDMI distribution.
APPLICATIONS
- Simultaneously display one HDMI source on two TVs/projectors
- Showroom display
- University lecture hall display
- Retail sales display
- Commercial presentation switcher/scaler
FEATURES
-
Integrated HDCP decryption/encryption engines which are compliant with HDCP Rev 1.4/2.2 specification
-
Wide Frequency Range: 25MHz – 600MHz
Supports HDTV resolutions up to 4K 60Hz -
Supports 4K@60Hz, Deep Color 12-bit
-
Supports LPCM 7.1CH, and DTS-HD Master Audio
-
Supports Full 3D
PACKAGE CONTENTS
- 1x 1×2 HDMI 2.0 4K@60HZ/HDCP 2.2 Splitter
- 1x 5 V/1A DC Power Supply Adaptor
- 1x User Manual
CONNECTION DIAGRAM
All brand names and trademarks are properties of their respective owners
SYSTEM REQUIREMENTS
- HDMI-equipped source devices such as a DVD/Blu-ray play with HDMI cables or DVI to HDMI cables
- HDMI-equipped displays (TVs or monitors) with HDMI cables
PANEL DESCRIPTIONS
OPERATION
-
1. Connect the HDMI cable from the HD source to the input port of this HDMI Splitter.
- Connect the HDMI cables from your displays (monitor or projector) to the outputs of this Splitter.
- Plug the 5VDC power supply into this HDMI Splitter.
- Turn on the power then the HDTV signal will be distributed to each HDTV display.
HDMI OUTPUT
Connect each of the output ports to the HDMI display for simultaneous HDMI
distribution.
LINK LEDs
These LEDs will illuminate when the HDMI outputs are connected to the display
with the signal display on the screen.
HDMI INPUT
Connect the input port to the HDMI or DVI output of your source equipment such
as a DVD player or set-top box.
INPUT LED
The input led will illuminate when connect to an HDMI source.
POWER LED
The power LED will illuminate when the unit is powered. 5 V/DC: Connect the 5
V/DC power supply to the splitter and Plug the adaptor to the AC wall outlet.
SPECIFICATIONS
Note
When displaying a 3D signal with higher bandwidth than 225MHz or a 4K2K
resolution source, a High-Speed HDMI cable is required.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>