HENDEE 1903 Robotic Toys Instruction Manual
- June 6, 2024
- HENDEE
Table of Contents
1903 Robotic Toys
Instruction Manual
TRANSMITTER
CONTROLLER INSTRUCTION:
A. DIRECTION CONTROL
B. WALKIE TALKIE
C. SOUND EFFECTS
D. TONE EFFECTS
E. DEMO
F. SOUND EFFECTS PLAY
G. PROGRAMMING MODE
H. SPYMCWIE
I. ON/OFF SWITCH
FUNCTION DESCRIPTION
A. DIRECTION CONTROL
Move forward / backward / left / right
B. WALKIE TALKIE
Speaking to the microphone after pressing, it can transmit sound to the robot
in real-time.
C. SOUND EFFECTS
Toggle switch of three sounds effects (Cheer /GhosUFart), press button F to
play the sound.
D. TONE EFFECTS
Toggle switch of high-middle-low tone,press button B to speak in a different
tone.
E. DEMO
When pressed, the robot automatically demonstrates
F. SOUND EFFECTS PLAY
When pressed, the robot will play the sound selected by toggle switch C.
G. PROGRAMMING MODE
- Press button G to enter programming mode (robot eyes flashing, and making “beep-beep” sounds).
2. Press the direction buttons in programming mode to arrange actions.
3. After pressing button G again, the robot will automatically demonstrate according to the programmed actions.
H. SPY MODE
Hold button H to hear the sounds from the robot’s location.
I. ON/OFF SWITCH
INSTALLATION METHOD OF BATTERY
Open the battery cover and load three batteries of 3 AAA into the remote control and the robot
MAINTENANCE
- The quadcopter shall be cleaned regularly with a clean soft cloth.
- Avoid strong sunshine and heat.
- Keep away from water.
- Regular check is suggested and damaged parts shall be replaced in time.
APPEND MANUAL
Produce name: ROBOTIC TOYS
Model: 1903
Manufacturer: GUANGDONG HENGDI TECHNOLOGY CORP., LTD.
Address: THE WEST OF NINGCHUAN ROAD AND THE SOUTH OF HUANCUI ROAD,
SHANGHAI ZONE, SHANTOU CITY, GUANG DONG, CHINA
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures: -Reorient or
relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.