avalue Technology UB-T100 UWB Tag Tracker User Guide

June 6, 2024
avalue Technology

Technology UB-T100 UWB Tag Tracker
User Guide

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/ TV technician for help.

CAUTION:
Any changes or modifications not expressly approved by the grantee of this device could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

A Message to the Customer

Avalue Customer Services
Each and every Avalue product is built to the most exacting specifications to ensure reliable performance in the harsh and demanding conditions typical of industrial environments. Whether your new Avalue device is destined for the laboratory or the factory floor, you can be assured that your product will provide the reliability and ease of operation for which the name Avalue has come to be known.
Your satisfaction is our primary concern. Here is a guide to Avalue’s customer services. To ensure you get the full benefit of our services, please follow the instructions below carefully.

Technical Support
We want you to get the maximum performance from your products. So if you run into technical difficulties, we are here to help. For the most frequently asked questions, you can easily find answers in your product documentation. These answers are normally a lot more detailed than the ones we can give over the phone. So please consult the user’s manual first.
To receive the latest version of the user’s manual; please visit our Web site at: http://www.avalue.com.tw/

Getting Started

Safety Precautions

Warning!
Always completely disconnect the power cord from your chassis whenever you work with the hardware. Do not make connections while the power is on. Sensitive electronic components can be damaged by sudden power surges. Only experienced electronics personnel should open the PC chassis.

Caution!
Always ground yourself to remove any static charge before touching the CPU card. Modern electronic devices are very sensitive to static electric charges. As a safety precaution, use a grounding wrist strap at all times. Place all electronic components in a static-dissipative surface or static-shielded bag when they are not in the chassis.

Packing List

1 x USB Charging Cable

System Specifications

UWB RF Specifications

Chip| Decawave DW1000
Physical rate| 850Kbps
6.8 Mbps
Antenna peak gain| 2.6dBi
UWB RF Specifications
Chip| Decawave DW1000
Physical rate| 850Kbps
6.8 Mbps
Software
UWB operating mode| TDoA
Warning| SOS, emergency button Low Power
System
Indicator Light| LED 1 (Green): Power Status
In normal mode, the LED indicator OFF
LED 2 (RGB): Battery Status
When fully charged, the LED indicator remains lit Blue.
When charging, the LED indicator flashes Orange.
When low power, the LED indicator flashes red.
When normal battery power, the LED indicator OFF
Others| 1 x Button
When pressing the button, Tag will broadcast ONE UWB signal package
Mechanical
Power Connector Type| Magnetic Charging
Power Requirement| +5V DC-in
Dimension| 90 x 60 x 10mm
Weight| 0.27kg
Color| Black / White / Gray
Reliability
EMI Test| CE/FCC ClassB
Safety| UL/CB design compatible
Operating Temperature| 0°C-40°C
Operating Humidity| 40°C @ 9 5 °/o Relative Humidity, Non-condensing
Storage Temperature| -40°C-90°C

Note: Specifications are subject to change without notice.

System Overview
Label Function
LED1 Battery Status
LED2 Power Status
BUTTON Send Signal
POWER Connector Magnetic Charging

System Dimensions

Operating

Copyright Notice
Copyright © 2020 Avalue Technology Inc., ALL RIGHTS RESERVED.

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals