SATECHI ST-BTMR2M R2 Bluetooth Multimedia Remote Control User Manual
- June 6, 2024
- SATECHI
Table of Contents
SATECHI ST-BTMR2M R2 Bluetooth Multimedia Remote Control
FUNCTIONS
KEY FUNCTION TABLE
| MULTIMEDIA MODE| PRESENTATION MODE
---|---|---
| Volume+| Up Arrow
| Volume –| Down Arrow
| Backward| Left Arrow
| Forward| Right Arrow
| Play/Pause| Enter
| Home| Home
| Siri| Mouse On/Off
| Mute| Left Click
| Virtual Keyboard| Right Click
2. Status indicator
3. Multimedia/ Presentation Mode Switch
4. USB-C Charging Port
5. Bluetooth Paring Button
6. Power Switch
ON/OFF
PAIRING
CHARGING
- The remote will reconnect to the last device automatically when power off and re-power on.
- Long Press (5s) the pairing button, the remote will disconnect with the last device and wait for new pairing.
FCC
This device complies with part 15 of the FCC results.
Operation is subject to the following two conditions:
- This device may not cause harmful interference and
- This device must accept any interference received, including interference that may cause undesired operation.
Note: This Equipment has been tested and found to comply with the limits for a class B digital device. pursuant to Part 15 oft he Federal Communications Commission (FCC) rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and. if not installed and used in accordance with the instructions, may cause harmful interference to radio communications, However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception. which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
1.1. Reorient or relocate the receiving antenna.
1.2. Increase the separation between the equipment end receiver.
1.3. Connect the equipment into and outlet on a circuit different from that to
which the receiver is connected
1.4. Consult the dealer or an experienced radio/TV technician for help.
Cautions: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment complies with FCC radiation eKposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
CE DECLARATION OF CONFORMITY
Satechi declares that this product is in compliance with the essential
requirements and other relevant provisions of applicable EC directives. For
Europe, a copy of the Declaration of Conformity for this product may be
obtained by visiting www.satechi.neUdoc
CAUTION
– Risk of explosion if the battery is replaced by an incorrect type
– disposal of a battery into fire or a hot oven, or mechanically crushing or
cutting of a battery, that can result in an explosion;
– leaving a battery in an extremely high temperature surrounding environment
that can result in an explosion or the leakage of flammable liquid or gas;
– a battery subjected to extremely low air pressure that may result in an
explosion or the leakage of flammable liquid or gas.
+1858 2681800
support@satechi.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>