SATECHI ST-Q2CCM Qi2 Wireless Car Charger User Manual
- June 1, 2024
- SATECHI
Table of Contents
ST-Q2CCM Qi2 Wireless Car Charger
User Manual
Qi2 Wireless Car Charge
ANGLE ADJUSTMENT
- Vent mount can adapt to horizontal or vertical car vents by turning clamp 90 degrees.
- Adjust viewing angle by turning the charger 30 degrees up, down, left or right.
IMPORTANT
- Only compatible with MagSafe phone cases or cases with magnets included.
- In order to reach 15W charging, phone must support MagSafe or Qi2 technology.
FUNCTIONS
- Qi2 Magnetic Wireless Charger (Max. 15W)
- Adjustable Hinge
- Air Vent Mount
- USB-C Connector
CHARGING YOUR DEVICES
RF exposure statement
This equipment complies with the FCC RF radiation exposure limits set forth
for an uncontrolled environment. This equipment should be installed and
operated with a minimum distance of 20cm between the radiator and any part of
your body.
This equipment meets the exemption from the routine evaluation limits in
section 2.5 of RSS-102. It should be installed and operated with a minimum
distance of 20cm between the radiator and any part of your body.
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user’s authority to
operate the equipment.
CE DECLARATION OF CONFORMITY
Satechi declares that this product is in compliance with the essential
requirements and other relevant provisions of applicable EC directives. For
Europe, a copy of the Declaration of Conformity for this product may be
obtained by visiting https://satechi.net/support/doc
WEEE Information
According to the WEEE (Waste Electrical and Electronic Equipment)
Directive, do not dispose of this product as household waste or commercial
waste. Waste electrical and electronic equipment should be appropriately
collected and recycled as required by practices established for your country.
For information on recycling of this product, please contact your local
authorities, your household waste disposal service, or the shop where you
purchased the product.
IC WARNING
This device contains licence-exempt transmitter(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
PKG TEAM
Designer: Gabriela Ramirez
Product: Qi2 Wireless Car Charger
Project: Product Manual Design
Date: APR/17/24
Scale: 100%
COMMENTS
Please do not print this layer!!!
-100% actual size
– All print should be matte except where indicated
SPECIFICATIONS
Printing Information
Paper Material + Specs
Folding
6-PANEL
ZIG-ZAG FOLD
Product Info
SKU: ST-Q2CCM
FCCID: N/A
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>