H Koenig stc56 700W Bagless Vacuum Cleaner Instruction Manual
- June 5, 2024
- H Koenig
Table of Contents
stc56 700W Bagless Vacuum Cleaner
Instruction Manualhttps://goo.gl/b13hk9
STRUCTURE OF THE PRODUCT
1 | Brush tool | 9 | Winding device button |
---|---|---|---|
2 | Extending metal tube | 10 | Back wheel |
3 | Power button | 11 | Back wheel rubber |
4 | Handle | 12 | Crevice nozzle |
5 | Handle of the dust cup | 13 | Accessory holder |
6 | Hose | 14 | Round brush |
7 | Hose connector | 15 | Furniture brush |
8 | Dust cup |
Safety warning
-
Be sure to use the cleaner in compliance with the contents of this manual, and use the fittings designated by the manufacturer.
-
Please do not leave the cleaner when it is powered on.
Turn off the power switch and pull out the power plug when not using or before maintenance. -
Please do not pull or carry the cleaner by the power cord, or nip it when closing a door; keep the cord free from the press of the cleaner.
-
Please do not let children take the cleaner as a toy, and close attention is necessary when the cleaner approaches children.
-
Please do not use the cleaner when its power cord or plug is damaged. Send it to the appointed service center. Please do not unplug by pulling the cord or plug. To unplug, grasp the plug, not the cord.
-
Never pull the power plug or use the cleaner with wet hands.
-
When using the cleaner, pay attention to prevent any hair roll or other rubbish block up the air inlet (including the hose and the spile), otherwise, motor failure and housing distortion may be caused. If the matter absorbed forms a blockage, stop the cleaner by pulling out the power plug immediately to clean the blockage.
-
When using the cleaner, don’t plug up the air outlet with a towel or other matters, otherwise, the efficiency of dust absorbance will be influenced, and the motor will be at high risk of being burnt out.
-
Never use the cleaner on uneven floors or ground, and be very careful when cleaning stairs to prevent the cleaner from falling down.
-
Never absorb live stumps with the cleaner, otherwise, the motor may be damaged.
-
The cleaner should be kept far away from heat sources (such as central heating, oven, etc) to avoid the distortion of plastic parts as well as the influence caused by such distortion.
-
Before using the cleaner, please remove big and sharp matters on the floor to avoid damaging the plastic parts, filter gauzes, and motor.
-
Never absorb water or other liquid with this cleaner, otherwise, the motor will be damaged.
-
This appliance may be used by persons with reduced physical, sensory or mental capabilities or lack of experience or knowledge, provided that they are supervised or instructed in the safe use of the appliance and that they fully understand the potential hazards.
-
If the power cord is damaged, it must be replaced with after-sales service to avoid any danger.
-
Do not operate this appliance if it has a damaged cord or plug, if it is not working properly or if it has been damaged or dropped. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent, or a similarly qualified person in order to avoid a hazard.
-
This appliance may be used by children of at least 8 years of age, as long as they are supervised and have been given instructions about using the appliance safely and are fully aware of the dangers involved.
-
Cleaning and maintenance should not be carried out by children unless they are at least 8 years of age and are supervised by an adult.
-
Keep the appliance and its power cord out of reach of children under 8 years of age.
-
When using electrical equipment, safety precautions must always be taken to prevent the risk of fire, electric shock and/or injury in the event of misuse.
-
Make sure that the voltage rating on the type plate corresponds to the main voltage of your installation. If this is not the case, contact the dealer and do not connect the unit
-
Never leave the unit unattended while in operation.
-
Make sure the power supply is 220-240V 50Hz
-
Your appliance has been designed for domestic use only. It is not intended for use in the following situations which are not covered by the warranty:
– in staff kitchen areas in shops, offices, and other professional environments,
– in farm hostels,
– by guests in hotels, motels, and other residential environments,
– in bed and breakfast-type environments.
HOW TO USE
ASSEMBLY BEFORE USE
Fig.1 shows the connection between the hose and the vacuum cleaner:
Put the hose connector in front of the vacuum cleaner. Then insert it into the
inlet hole and turn right. If you want to disassemble it, you can turn the
hose connection left and then pull it out.
Fig.2 shows the connection between the hose and the extending metal tube:
Hold the flexural connector of the hose and put it into the bigger hole of the
tube.
Fig.3 shows the connection between the tube and the brush tool:
Put the metal tube into the hole of the brush and rotate it to fasten them.
Fig.4 shows how to check the winding of the power cord.
You can pull the power cord out of the machine and stop it when you see the
yellow mark.
Make sure the red mark is not out. When your sweep is over, first turn off the
power, pull the plug out of the socket, and then push the winding device
button until the cord is completely in the machine.
Fig.5 shows the power button
Put the plug into the socket, and push the power button to control the work of
the machine.
CLEANING OF THE DUST CHAMBER
The steps of the chamber cleaning:
- As in Fig.6, hold the dust chamber and handle and push the release button.
- As in Fig.7, take the dust chamber out of the machine.
- As in Fig.8, put the dust chamber onto the rubbish bin, push the release button to open the bottom of the dust chamber, and the dirt and dust will fall into the bin by themself.
- As in Fig.9, shut up the dust chamber for a circular use after your cleaning.
MAINTENANCE
HOW TO MAINTAIN
- The filter should be cleaned twice a year, and when there is obvious dirt on the filter, it is time.
- You must fix the filter properly before running the vacuum cleaner.
- The filter can’t be cleaned in the washing machine or baked by the blower.
- It will reduce the suction power and damage the motor if you use the wet filter.
- Steps for maintenance:
- As in fig.10, press the outlet lock to open the outlet board.
- As in fig.11, get out the outlet filter.
- As in fig.12, rotate the HEPA cover to separate it from the chamber cover
- As in fig.13, get the HEPA cover
- As in fig.14, If you have any hair winding removable cleaning.
- As in fig.15, get the HEPA and wash it.
- Wash the HEPA cover, the HEPA assembly, the outlet sponge and the dust chamber in the water without detergent and dry them before use.
- Put the dust chamber assembly into the machine. And in this process, first,
you should make the chamber in the right position and then press the handle of
the dust chamber, if there is a cluck it means the operation is successful.
Correct Disposal of this product
This marking indicates that this product should not be disposed of with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmentally safe recycling.
Adeva SAS / H.Koenig Europe – 8 rue Marc Seguin – 77290 Mitry Mory –
France www.hkoenig.com –
sav@hkoenig.com –
contact@hkoenig.com – Tél:
+33 1 64 67 00 05
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>