H Koenig joe48 Metal Table Fan Instruction Manual

joe48 Metal Table Fan
Instruction Manualhttps://goo.gl/fw5nnz

PLEASE READ THE INSTRUCTIONS CAREFULLY

BEFORE OPERATING

Sleek & modern high-velocity fan provides more powerful wind than ordinary plastic fans. Draws air off the floor and circulates through the entire room keeping room cool and breezy. Put near the windows and it helps exhaust hot indoor stuffy air and pulls in fresh outdoor air.

• Energy-saving, high-velocity motor for maximum air circulation
• Tilt adjustment for flexible use
• Triple speed selection
• Precision fan blades for powerful wind but low-noise Chrome-stand, solid construction with thermal- protection to prevent motor overheating.
  

IMPORTANT SAFETY INSTRUCTIONS

• Only use the fan under the conditions described in this manual. Any other use is not recommended and may result in fire, injury, or electric shock.

• This appliance may be used by persons with reduced physical, sensory or mental capabilities or lack of experience or knowledge, provided that they are supervised or instructed in the safe use of the appliance and that they fully understand the potential hazards.

• This appliance may be used by children of at least 8 years of age, as long as they are supervised and have been given instructions about using the appliance safely, and are fully aware of the dangers involved.

• Cleaning and maintenance should not be carried out by children unless they are at least 8 years of age and are supervised by an adult.

• Keep the appliance and its power cord out of

• reach of children under 8 years of age.

• When using electrical equipment, safety precautions must always be taken to prevent the risk of fire, electric shock, and/or injury in the event of misuse.

• Make sure that the voltage rating on the typeplate corresponds to the main voltage of your installation.
  If this is not the case, contact the dealer and do not connect the unit

• Never leave the unit unattended while in operation.

• Please keep this document at hand and give it to the future owner in case of transfer of your device

• The device is not intended to be operated by external timer means or a remote control system

• Do not use the appliance if it has a damaged cord or plug if it is not working properly if it has been damaged or dropped. If the power cable is damaged, it must be replaced by the manufacturer or his agent or by a qualified person to avoid any hazard.

• Children should be supervised to make sure they do not play with the device.

• Cleaning and maintenance of the appliance must not be done by a child.

• Never remove the cover before unplugging the unit.

• The device must not be used if it has dropped if there are visible signs of damage.

• Unplug the appliance if it is not used.

• Do not use the fan near a gas or fire source, in a very humid, hot, or unstable environment.

• Never put your fingers in the protective grilles or touch the moving parts of the appliance.

• Do not use the unit with a speed control system.

• Young children, the elderly, or the suffering should not be exposed directly to the blower for a long time.

• Make sure the fan is always on a flat, dry and stable surface.

• NEVER COVER THE APPLIANCE, even temporarily, as it may overheat and create a fire hazard.

• Your appliance has been designed for domestic use only. It is not intended for use in the following situations which are not covered by the warranty:
  – in staff kitchen areas in shops, offices, and other professional environments,
  – in farm hostels,
  – by guests in hotels, motels, and other residential environments,
  – in bed and breakfast-type environments.

OPERATING INSTRUCTIONS:

a) Ensure the voltage used corresponds with the voltage indicated.
b) Turn the speed control to selected speeds: 0(off) and speedsⅠ, Ⅱ, Ⅲ is Slow, Middle, Fast.
c) Tilting angles-By pushing the tilt-guard, you can adjust the fan to any elevation preferred.

INSTALLATION

Step-1: screw out the 4pcs screws from the fan motor housing
Step-2: put the rear fan guard touch the fan motor housing, screw the screws back to lock the rear fan guard
Step-3: Insert the fan blade into the motor shaft,
Step-4: tight the screw to control the fan blade

Step-5: Put the front fan guard on the rear fan guards, put back the clips to control the fan guards well (at the bottom of the fan guard, there is a safety screw, install them into the  rear fan guard hole and tight it)
Step-6: Contact the electrical for using

SECURITY GUIDE

• Never touch the blades with your hand or any object!
• Do not pull the cord too hard. If damaged after pro-long use, get it repaired by any electrical repairman
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons in order to avoid a hazard.

CLEANING

To clean: Disconnect the power cord from the mains.
Remove the guard and the blades carefully. Do not drop the blades! First, use a soft cloth with light soap to clean off oil stains. Then wipe and polish with a dry cloth. Never use polish or any corrosive liquid that will damage the paint, metal, or plastic! Put back the blades and lock the guard securely before use. NO exchange will be entertained if the above instructions are not followed. Always test the product first before purchase.

TECHNICAL INFORMATION

Operating Voltage: 220-240V~ 50Hz
Power Consumption: 35W

ENVIRONMENT
CAUTION: Do not dispose of this product as it has with other household products. There is a separation of this waste product into communities, you will need to inform your local authorities about the places where you can return this product. In fact, electrical and electronic products contain hazardous substances that have harmful effects on the environment or human health and should be recycled. The symbol here indicates that electrical and electronic equipment should be chosen carefully, a wheeled waste container is marked with a cross.

Adeva SAS / H.Koenig Europe – 8 rue Marc Seguin, 77290 Mitry-Mory, France
www.hkoenig.com – https://en.hkoenig.com – Tél: +33 1 64 67 00 05

References

• H.Koenig : Le spécialiste du petit électroménager
• HKOENIG SAV: Pezzi di ricambio, accessori, FAQ
• H.Koenig customer support
• HKOENIG SAV: Repuestos, accesorios, FAQ
• HKOENIG SAV: Pièces détachées ,accessoires, FAQ

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>