H Koenig joe32 Metal Floor Fan Instruction Manual

: June 5, 2024
: H Koenig

Table of Contents

IMPORTANT SAFETY INSTRUCTIONS
OPERATING INSTRUCTIONS:
CLEANING AND MAINTENANCE:
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

joe32 Metal Floor Fan
Instruction Manualhttps://goo.gl/fw5nnz

IMPORTANT SAFETY INSTRUCTIONS

This appliance may be used by children of at least 8 years of age, as long as they are supervised and have been given instructions about using the appliance safely and are fully aware of the dangers involved.
This appliance may be used by persons with reduced physical, sensory or mental capabilities or lack of experience or knowledge, provided that they are supervised or instructed in the safe use of the appliance and that they fully understand the potential hazards.
Cleaning and maintenance should not be carried out by children unless they are at least 8 years of age and are supervised by an adult.
Keep the appliance and its power cord out of reach of children under 8 years of age.
When using electrical equipment, safety precautions must always be taken to prevent the risk of fire, electric shock and/or injury in the event of misuse.
Make sure that the voltage rating on the typeplate corresponds to the main voltage of your installation. If this is not the case, contact the dealer and do not connect the unit.
Never leave the unit unattended while in operation.
Please keep this document at hand and give it to the future owner in case of transfer of your device
The device is not intended to be operated by an external timer means or a remote control system
Do not use the appliance if it has a damaged cord or plug if it is not working properly if it has been damaged or dropped. If the power cable is damaged, it must be replaced by the manufacturer or his agent or by a qualified person to avoid any hazard.
Children should be supervised to make sure they do not play with the device.
Cleaning and maintenance of the appliance must not be done by a child.
Never remove the cover before unplugging the unit.
The device must not be used if it has dropped if there are visible signs of damage.
Unplug the appliance if it is not used.
Do not use the fan near a gas or fire source, in a very humid, hot, or unstable environment.
Never put your fingers in the protective grilles or touch the moving parts of the appliance.
Do not use the unit with a speed control system.
Young children, the elderly, or the suffering should not be exposed directly to the blower for a long time.
Make sure the fan is always on a flat, dry and stable surface.
NEVER COVER THE APPLIANCE, even temporarily, as it may overheat and create a fire hazard.
Your appliance has been designed for domestic use only.
It is not intended for use in the following situations which are not covered by the warranty:
– in staff kitchen areas in shops, offices, and other professional environments,
– in farm hostels,
– by guests in hotels, motels, and other residential environments,
– in bed and breakfast-type environments.

Sleek & modern high-velocity fan provides more powerful wind than ordinary plastic fans. Draws air off the floor and circulates through the entire room keeping room cool and breezy. Put near the windows and it helps exhaust hot indoor stuffy air and pulls in fresh outdoor air.

Energy-saving, high-velocity motor for maximum air circulation
Tilt adjustment for flexible use
Triple speed selection
Precision fan blades for powerful wind but low-noise
Chrome-stand, solid construction with thermal-protection to
Prevent motor overheating.
Versatile use can be put on the floor, desk or mounted on the wall

1. Guard clips	12. The gasket for the base
2. Hook	13. Square bolt
3. Front protective grid	14. Locknut
4. Blade	15. Tube base
5. Rear protective grid	16. Locknut
6. Fastening screw for protective grid	17. Front plastic gasket
7. Washer for switch	18. The gasket for the base
8. Switch	19. Square bolt
9. Power cord	20. Rear plastic gasket
10. Motor	21. Front plastic gasket

11. Flattened area on the Motor Shaft

OPERATING INSTRUCTIONS:

a) Ensure the voltage used corresponds with the voltage indicated.
b) Turn the speed control to the selected speeds:0(off) and speeds1,2,3 is Slow, Middle, Fast.
c) Tilting angles-By pushing the tilt-guard, you can adjust the fan to any elevation preferred.
d) Never touch the blades with your hand or any object!
e) Do not pull the cord too hard. If damaged after pro-long use, get it repaired by any electrical repairman.
f) To clean: Disconnect the power cord from the mains. Remove the guard and the blades carefully.
Do not drop the blades! First, use a soft cloth with light soap to clean off oil stains. Then wipe and polish with dry cloth. Never use polish or any corrosive liquid that will damage the paint, metal, or plastic! Put back the blades and lock the guard securely before use.
g) To mount on walls, ensure strong, durable tools are used. Make sure it is properly and firmly drilled into the wall to support the weight of the fan.
NO exchange will be entertained if the above instructions are not followed. Always Test the product first before purchase.

CLEANING AND MAINTENANCE:

To clean: Unplug the power cord, remove the protector and blades carefully, do not drop the blades, use a soft cloth with mild soap first to remove oil stains, then wipe and polish with a dry cloth, never using polish or corrosive liquids that could damage the paint, metal or plastic, replace the blades and close the guard in place before use.
Do not use abrasive cleaning chemicals or detergents that could easily damage or deform your device.

ENVIRONMENT
CAUTION: Do not dispose of this product as it has with other household products. There is a separation of this waste product into communities, you will need to inform your local authorities about the places where you can return this product. In fact, electrical and electronic products contain hazardous substances that have harmful effects on the environment or human health and should be recycled. The symbol here indicates that electrical and electronic equipment should be chosen carefully, a wheeled waste container is marked with a cross.

Adeva SAS / H.Koenig Europe – 8 rue Marc Seguin, 77290 Mitry-Mory, France
www.hkoenig.com – https://en.hkoenig.com – Tél: +33 1 64 67 00 05