H Koenig hf340 Vertical Ice Cream Maker Instruction Manual
- June 5, 2024
- H Koenig
Table of Contents
H Koenig hf340 Vertical Ice Cream Maker
INSTRUCTION MANUAL
Read this booklet thoroughly before using and save it for future reference
IMPORTANT NOTICES
When using an electrical appliance, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and/or injury, including the following:
- Read all instructions before using.
- Ensure the voltage is compliant with the voltage range stated on the rating label, and ensure the earthing of the socket is in good condition.
- If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
- Do not upend this product or incline it over a 45℃ angle.
- To protect against risk of electric shock, do not pour water on cord, plug and ventilation, immerse the appliance in water or any other liquid.
- Unplug the appliance after using or before cleaning.
- Keep the appliance 8cm from other objects to ensure the good heat releasing.
- Do not use the accessories which are not recommended by Manufacturer.
- Do not use the appliance close by flames, hot plates or stoves.
- Do not switch on the power button frequently (ensure 5min. interval at least) to avoid the damage of compressor.
- Metal sheet or other electric objects are not allowed to be inserted into the appliance to avoid fire and short circuit.
- When take out the ice cream, do not knock the barrel or edge of barrel to protect the barrel from damage.
- Do not switch on the power before install well the barrel or blender blade.
- The initial temperature of the ingredients is 25±5℃.Do not put the ingredients into freezer for pre-freeze, as it will easily make the blender blade blocked before the ice cream is in good condition.
- Do not remove the blender blade when the appliance is on working.
- Do not use outdoors.
- Never clean with scouring powders or hard implements.
- Please keep the instruction manual.
- This appliance may be used by persons with reduced physical, sensory or mental capabilities or lack of experience or knowledge, provided that they are supervised or instructed in the safe use of the appliance and that they fully understand the potential hazards.
- Children should be supervised to ensure that they do not play with the appliance.
- The device must not be used if it has been dropped, it obvious signs of damage are visible or if it has leaks.
- The plug must be removed before cleaning, maintaining or filling the appliance
- This appliance may be used by children of at least 8 years of age, as long as they are supervised and have been given instructions about using the appliance safely and are fully aware of the dangers involved.
- Cleaning and maintenance should not be carried out by children unless they are at least 8 years of age and are supervised by an adult.
- Keep the appliance and its power cord out of reach of children under 8 years of age.
- When using electrical equipment, safety precautions must always be taken to prevent the risk of fire, electric shock and/or injury in the event of misuse.
- Make sure that the voltage rating on the typeplate corresponds to your main voltage of your installation. If this is not the case, contact the dealer and do not connect the unit
- Never leave the unit unattended while in operation.
- Please keep this document at hand and give it to the future owner in case of transfer of your device
- The device must not be used if it has been dropped, it obvious signs of damage are visible or if it has leaks.
- Do not use outside.
- This appliance is intended for use in domestic and similar applications such as :
- kitchen areas in shops, offices and other working environments
- farmhouses
- in hotels, motels and other residential environments
- guest rooms
- When using electrical equipment, safety precautions must always be taken to prevent the risk of fire, electric shock and/or injury in the event of misuse.
- Make sure that the voltage rating on the typeplate corresponds to your main voltage of your installation. If this is not the case, contact the dealer and do not connect the unit.
- Never leave the unit unattended while in operation.
- lease keep this document at hand and give it to the future owner in case of transfer of your device.
- The device is not intended to be operated by external timer means or a remote control system.
- This appliance is only intended for domestic and indoor use.
- Warning : Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
- Warning : Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction
- Warning : Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer
- Warning : Do not damage the refrigerant circuit
- Warning: Do not use electrical appliances inside the food
Warning: When disposing of the appliance, do so only at an authorized waste disposal centre. Do not expose to flame. The refrigerant isobutene (R600a) is contained within the refrigerant circuit of the appliance, a natural gas with a high level of environmental compatibility, which is nevertheless flammable. During transportation and installation of the appliance, ensure that none of the components of the refrigerant circuit becomes damaged. The refrigerant (R600a) is flammable.
Caution: risk of fire
If the refrigerant circuit should be damaged:
- Avoid opening flames and sources of ignition.
- Thoroughly ventilate the room in which the appliance is situated.
SPECIFICATIONS PARTS & FEATURES
Structure
Function buttons
[POWER]:
After power up, the machine enters standby mode. Then press the [POWER] button
to enter the setting mode, and LCD will display “60:00” and light up the
background light. If no other operation, the light will go off 15 seconds
later; then press the [POWER] button again; the machine can go back to standby
mode.
[MENU]:
By pressing this button, there are 3 working modes for option, including:
[ICE CREAM] [COOLING ONLY] and [MIXING ONLY]; the icon “■” of the selected
mode will flash. Holding this button for 3 seconds during mode operation, the
machine will go back the menu selection.
Time setting knob :
Turn the knob to set working time, the default working time to [ICE CREAM]
[COOLING ONLY] and [MIXING ONLY] is 60min, 30min, 10min, respectively.
Rotating the knob to “-“ can decrease the working time, the minimum setting
time is 5min. Contrarily, rotating to “+” can increase time, the maximum
setting time is 60min.
[START/PAUSE] :
After setting the menu and time, press this button to start the working mode.
During operation, by pressing this button, the mixing will pause and the time
countdown will pause also. At pause mode, press this button again, the machine
will continue the previous unfinished operation. Once the ice cream maker
enters pause mode and no other operation, the compressor will stop working
3min later and the machine will go back to standby state 10min later.
MAKING ICE CREAM
Cleanness: Before use, thoroughly wash all parts that will come into contact with the ice cream (including the fixed bowl, removable bowl, mixing blade, transparent lid, refill lid, measuring cup and spoon).
Warning: Please be sure the power cord is unplugged.
Important: Always place the Ice Cream Maker upright on a flat surface in order that the build-in COMPRESSOR can provide best performance.
-
Step 1. Prepare recipe ingredients:
Prepare recipe ingredients from your own recipe or from the recipe booklet here. Note: You do not need to freeze the bowl for hours in a freezer in advance, as this machine has a BUILT-IN COMPRESSOR that freezes the recipe ingredients in operation thus ensure the output of ice cream. -
Step 2. Pour the well-prepared recipe ingredients into the removable bowl,(see photo below)
-
Step 3. Put the removable bowl into the machine and slightly turn around the bowl to make it fitted well with the fixed bowl (See below picture).
-
Step 4. Place the mixing blade into the removable bowl and keep the mixing blade bottom hole fitted well with the motor axis. Then put the transparent lid onto the machine and lock it anticlockwise (See below picture).
-
Step 5. Plug in power, and press the [POWER] button to make the machine electrified.
-
Step 6. Press the [MENU] button to choose the working mode.
-
Step 7. Turn the knob to set the working time.
-
Step 8. Press the [START/PAUSE] button to start working.
-
Step 9. You can add the favorite ingredients by opening the refill cover (See below picture).
-
Step 10. After the operation is over, turn off the machine first, and then pull the removable bowl out.
OPERATION
Keep cool function
To avoid melting when the ice cream is not placed well in time, the following
design is supported: After the ice cream is finished and without any other
operation, the machine will start up the keep cool function automatically,
which can keep cool for 2 hours. Two hours later, machine will enter standby
state.
Motor self-protection function
When the ice cream becomes harder, the mixing motor might be blocked. Then the
motor protection device makes the mixing motor stop working by detecting its
temperature to ensure the life of the motor.
Controlling the Volume of the Ingredients
To avoid overflow and waste, please make sure that the ingredients do not
exceed 60% of capacity of the removable bowl (Ice cream expands when being
formed)
The Differences Among These Three Working Mode
- Ice cream mode: the default working time is 60 minutes. The detailed operation is instructed as above.
- Cooling only mode, the default working time is 30 minutes. The operation is similar with that of ice cream mode, but there isn’t mixing function.
- Mixing only mode, the default working time is 10 minutes. The operation is similar with that of ice cream mode, but there isn’t freezing function.
Storage of ice cream
Remove finished ice cream into another container using a plastic scoop or a
wooden spoon, do not use a metal scoop avoiding scratch on the inside
removable bowl.
MAINTENANCE
Caution : The plug must be removed before cleaning to avoid electric shock.
- Take out the mixing blade, wipe it with a dampened cloth
- Take out the removable bowl, clean it with a dampened soft cloth
- Wipe the transparent lid and refill lid with a dampened cloth
- Remove the dirty on the body or other places with a dampened cloth, and do not pour water on cord, plug and ventilation, immerse the appliance in water or any other liquid
- Allow drying thoroughly with a dry cloth, then return the component to the home position.
ENVIRONMENT
CAUTION:
Do not dispose of this product as it has with other household products. There
is a separation of this waste product into communities, you will need to
inform your local authorities about the places where you can return this
product. In fact, electrical and electronic products contain hazardous
substances that have harmful effects on the environment or human health and
should be recycled. The symbol here indicates that electrical and electronic
equipment should be chosen carefully, a wheeled waste container is marked with
a cross.
Adeva SAS / H.Koenig Europe – 8 rue Marc Seguin, 77290 Mitry-Mory, France www.hkoenig.com – https://en.hkoenig.com – Tél: +33 1 64 67 00 05
References
- H.Koenig : Le spécialiste du petit électroménager
- HKOENIG SAV: Pezzi di ricambio, accessori, FAQ
- H.Koenig customer support
- HKOENIG SAV: Repuestos, accesorios, FAQ
- HKOENIG SAV: Pièces détachées ,accessoires, FAQ
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>