VICXXO 15W Fast Wireless Charging Roller Car Phone Holder User Manual
- June 5, 2024
- VICXXO
Table of Contents
VICXXO 15W Fast Wireless Charging Roller Car Phone Holder User Manual
Product Description
Instructions
-
Rotate the chuck ball shaft to the charger to ensure that the charger can rotate flexibly.
-
Input power supply: Connect the charging adapter and charging wire to the charger,adn the indicator light is to indicate that the charger start to work.
-
Press clamp is fixed on the air outlet of automobile air conditioner, then adjust the direction and tighten the nut.
-
Push the reset button . the clamp will be released. Place phone in jaws and push the clamps until phone is held securely.
-
Place phone slantly. Push the other side of phone to the jaws along the roller.
-
To remove phone, slightly push the right roller and easily take out phone along the roller.
Function Description
- Fits for Qi standard mobile phones;
- Support 15W fast charging , as well as 10W / 7.5W /5W wireless charging;
- Push the reset button , and place phone in jaws slantly then push the clamps to hold the phone securely;
- The arm clamp can be flexibly extended, so it is easy to hold different mobile phones;
- Fixed the clip clamp at the air vent outlet of the car, it can be adjusted 360° in 360 degrees to the direction of your phone;
- This wireless charger comes with over-current protection, overheat protection, short circuit protection;
- Product certification: FCC, CE, ROHS
Product Parameters
- Material: ABS + PC.
- Input power: 5V2A, 9V/2A.
- Output power: 15W (Max).
- Effective Distance of Wireless Charging: 3-6mm.
- Conversion efficiency: Standard charging ≥70% fast charging ≥75%.
- Working frequency:110-205KHz.
Warranty instructions
12 months warranty from the day of purchase; Do not open or disassemble the product by yourself, it may cause damage to the product and invalidate your warranty service.
FCC Caution
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body. This transmitter
must not be co-located or operating in conjunction with any other antenna or
transmitter.
Documents / Resources
|
VICXXO 15W Fast Wireless Charging Roller Car Phone
Holder
[pdf] User Manual
CARMEL, 2AXZN-CARMEL, 2AXZNCARMEL, 15W Fast Wireless Charging Roller Car Phone
Holder
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>