viewneo VN-BTLR-01 Butler Device User Guide
- June 5, 2024
- viewneo
Table of Contents
viewneo VN-BTLR-01 Butler Device
INTRODUCTION
1. ADD BUTLER IN THE CMS Go to devices and add Butler to your viewneo
account.
2. CONNECT BUTLER with the power supply and if needed, the LAN cable.
Wait until the blue light appears to indicate that it is successfully
connected.
3 . SETUP HOTSPOT The Butler will automatically create a hotspot:
viewneobutler. Use your cell phone/PC to connect to the hotspot and then go
to: http://192.168.2.5
4. SETUP ASSISTANT Follow the instructions on your screen to complete the
setup process.
FCC Warning
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20cm between the radiator and your body.
HELP AND SUPPORT
Need help with viewneo® Cloud or viewneo® hardware? Find detailed information,
FAQs, tutorials and downloads at
support.viewneo.com.viewneo® is a trademark of
Advertising Media GmbH www.viewneo.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>