IKEA NYMANE Work Lamp with Charging LED Bulb Anthracite Instructions

NYMÅNE

|
---|---
|

Charger features

• Wirelessly charges Qi-compatible devices.
• Compatible with Qi 1.2.4BPP specification.
• Temperature and power monitor for safety.
• LED status indicator.
• USB-C outlet is compatible with Power Delivery 3.0 standard.
• USB-C to USB-A adaptor included.

Instructions for use

• For wireless charging, place the device to be charged on top of the plus sign (+) on the charger. The device must be placed directly over the plus sign (+) on the charger for the charging function to work optimally. Note that on some devices you may have to activate wireless charging in settings.
• If your battery is completely discharged, it may take a few minutes before it starts charging. This is entirely normal. You can see that the battery has begun charging when the battery symbol appears on your phone.
• When charging only use a recommended USB cable for your device and replace faulty cables eminently.
• Be sure to not exceed the maximum USB cable length recommended for the device.

LED indicator (see illustrations):

1. Power on: LED lights up for 3 seconds.
2. Charging: LED on.
3. Charging completed: LED off.
4. Error: LED flashes.

Good to know

• Devices may get warm during charging; this is completely normal and they will gradually cool down again after they are fully charged.
• Charging time may vary based on the device’s battery capacity, charge level, the age of the battery, and the temperature in the surrounding area.
• USB cable length and quality influence charging speed and performance.
• Charger storage temperature: -20°C to 25°C (-4°F to 77°F).
• Charger operating temperature: 0°C to 40°C (32˚F to 104˚F).
• Unplug the charger from the mains before cleaning and when it is not in use.
• To clean the product, wipe with a moist cloth. Never submerge the charger in water.

Note!
Never use abrasive cleaners or chemical solvents since this can damage the product.
Recommended precautionary measures and technical data. See the back of the product.
Save these instructions for future use.
WARNING:

• Only charge devices that are Qi-compatible.
• The wall socket must be located near the equipment and must be easily accessible.
• Only use in dry locations.
• Children should be supervised to ensure they do not play with the product.
• Never use a damaged or faulty USB cable for charging, since this can damage the product and harm your device.

Product servicing

Do not attempt to repair this product yourself, as opening or removing covers may expose you to dangerous voltage points or other risks.

Technical Data

Power supply unit wireless charger

Type:| KVM-B-190-190-NA
Input:| 110-120VAC, 50/60Hz, 0.39A
Output:| 19.0V DC, 1.0A, 19.0W

Power Supply Unit USB-C

Type:| ICPSW5-18-BI-1
Input:| 100-240VAC, 50/60Hz, 0.5A

Output:

USB-A adaptor:| 5.0V DC, 3.0A
USB-C:| 5.0V DC/3.0A 15.0W,
Max USB cable length:| 1.5 m (5 ft)

Indoor use only
Manufacturer: IKEA of Sweden AB
Address:
Box 702, SE-343 81 Älmhult, SWEDEN

The ‘Qi’ symbol is a trademark of the Wireless Power Consortium
RF EXPOSURE INFORMATION
According to RF exposure regulations, under normal operations, the end-user shall refrain from being closer than 10 cm from the device.
This device complies with Part 15 of the FCC Rules.
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation Science and Economic Development Canada’s license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation of the device.
WARNING:
Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The crossed-out wheeled bin symbol indicates that the item should be disposed of separately from household waste. The item should be handed in for recycling in accordance with local environmental regulations for waste disposal. By separating a marked item from household waste, you will help reduce the volume of waste sent to incinerators or and-fill and minimize any potential negative impact on human health and the environment.
For more information, please contact your IKEA store.

© Inter IKEA Systems B.V. 2020
AA-2281565-1

Documents / Resources

| IKEA NYMANE Work Lamp with Charging LED Bulb Anthracite [pdf] Instructions
NYMANE, Work Lamp with Charging LED Bulb Anthracite, NYMANE Work Lamp with Charging LED Bulb Anthracite
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>