Dr warm SR01 Remote Control Heated Socks User Manual

Dr warm SR01 Remote Control Heated Socks

IDENTIFYING PARTS

Dear customer, Thank you for purchasing Dr.warm Heated Socks. Please read this user manual carefully and keep it for future reference. If you need any further assistance, please contact our customer support team by sending us a message at service@drwarm.com.

SAFETY WARNINGSs

• DO NOT expose the product to moisture.
• DO NOT use the socks if they are wet, use them after drying.
• DO NOT place the batteries in the water, fire, liquid or use them in a high-temperature environment over 60 C/140°F. DO NOT put the batteries in mouth.
• DO NOT allow the wire to be pinched or cut
• DO NOT iron.
• DO NOT use if the socks stop working abnormally or heat inconsistently. Always turn off the device and disconnect the batteries when it is not in use. Dispose of the useless batteries properly according to the local law.
  CAUTION! If you feel uncomfortable tingling heat or if the skin turns red there is a risk of burns. Turn off the device immediately and stop using it. Read the safety warnings carefully before first use.

TECHNICAL SPECIFICATION

• Polymer Li-ion
• Batteries
• Battery Voltage: 7.4V Battery
• Capacity: 2600 mAh
• Charging Voltage Peak: 8.4t0.05V
• Minimum Discharging Voltage: 6V
• Charging Mode: CcICV
• Remote Controller
• Materials: AC Cotton
• Cotton: 35%
• Acrylic: 35%
• Nylon: 15%
• Spandex: 15%

FEATURES

Red:ln charging

Green Flashlight:Full or Standby

| 8.4V= 1.5A| 100-240V-

50/60Hz0.6A

•  Large capacity of 2600 mAh of Polymer Li-ion batteries (7.4V) Thermal and soft fabric
• Double high-tenacity wires of 35-pound tension capacity
•  Dual temperature controlling mode: remote and manual
•  Heats up quickly- in approx. 30 seconds
•  Ideal for outdoor activities, walking, running, skiing, cycling, motorcycling, or anyone working in a low-temperature environment
•  Only use the configured charger to charge the batteries.

HOW TO USE

• To Charge the Battery
  Fully charge the batteries before use. Note: The red light of the charger means that the battery is charging, when it turns to green light, it means that the battery charged already. These batteries can be fully charged in 4 hours.

• To Install the Battery
  Find the wire in the battery pocket, unplug the cap from the wire head. Connect the wire head to the battery. Put the battery into the pocket and button it up.

• To Turn On
  Press the power button on the sock or press the button on the remote controller. Select Low, Medium, or High to activate the heat settings (1 flash = low heat, 2 flashes= medium heat, 3 flashes= high heat) by pressing the button on the sock or the button on the remote controller.

• To Turn Off
  Press the power button on the sock until the indicator light is off or press the power button on the remote controller. Note: The remote controller will NOT work after you press the power button on the sock to turn it off. If you press the power button on the sock turning it off, you have to press the power button on the sock to turn it on or, disconnect the battery and reconnect it to the wire, then control it with the remote controller.

WORKING TEMPERATURE AND TIME

Heat Setting Low:| Temperature

35-45″C/95-113″F

| Time

7-8 hours

---|---|---
Medium:| 45-55″C/113-131 “F| 5-7 hours
High:| 55-65″C/131-149″F| 2-3.5 hours

Note: The data above was collected at a temperature of 25″C/77″F. The working temperature and time may change according to the ambient environment.

CARE INSTRUCTIONS

•  Turn off the socks when not in use.
•  Take out the battery for a long time unused.
•  Cover the wire head with its cap and wash the sock with water and neutral cleaner, and let it air dry. DO NOT use a hairdryer to dry the sock.
•  Put away the socks in a clean and dry place.
•  Only charge the batteries when they disconnect the socks.
•  DO NOT damage the heating elements by bending the socks vigorously.
• Charge the battery every 2-3 months to prolong the battery life. DO NOT overlay the sock on the other one when they are in the operation.

PACKAGE CONTENTS

• 2 x Heated Sock
• 2 x Battery
• 2 x Wire Head Cap
• 1 x Instruction Manual
• 1 x Battery Charger

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference
(2) This device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o ff and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radioTV technician for help.

RF warning statement: The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>