Slieve Bloom 145434 Solar Garden Water Feature and Planter Instruction Manual
- June 2, 2024
- Slieve Bloom
Table of Contents
Slieve Bloom 145434 Solar Garden Water Feature and Planter
Thank you for purchasing this fine decorative fountain. This product combines our latest design with a creative theme and is carefully packaged, inspected, and tested to ensure safe operation. The following instructions and safety guidelines will enable you to use the product for trouble-free operation. Please read the instructions and safety guidelines entirely before using the product. The product consists of: (1) Fountain Top (2) Reservoir (3) Solar Pump
Instructions for use
- Remove plastic bags from packaging. Read this instruction sheet before proceeding.
- Place base on a flat surface and insert the reservoir onto the base.
- Read user manual. Insert the water pump into the water tube.
- Insert fountain top on the reservoir and put the pump into the water. Water should be higher than the pump.
- Ensure the water tube is properly connected to the pump and not crimpled.
- The concave edge of the fountain top should adhere to the convex part of the reservoir. Be sure that the electric wire is passed through the wire opening.
- Connect the power cable to the outlet. If installed properly, water flow in the fountain will begin shortly.
- When the battery is fully charged and without any sunlight input, the pump will run for around 6-8 hours. If with strong sunlight input, usually could run for more than 8 hours.
- Please do not use it in adverse weather conditions.
Please note : There may be air in the pump on first use. It may take several minutes until all the air escapes.
Safety Guidelines
- Read all instructions and safety guidelines thoroughly. Failure to follow guidelines and instructions could result in serious injury and/or property damage.
- Do not pump flammable liquids such as gasoline or fuel oil with the fountain pump.
- Make sure the water tube is properly connected with the pump and the upper layer, and the tube is not crimpled. This could cause a blockage, and water will not come out.
- During operation, the area around the pump will be covered with water. Take care when handling the pump; do not pull it out of the water (when running) by the power cord, and do not move the product while in operation.
- To the solar pump to operate, the solar panel needs to be in direct sunlight. This solar pump is equipped with a battery pack and can be switched on and off by a touch switch on the control box.
Cleaning and Maintenance
- If, after time, the pump starts to lose power or stops working, you should check for the build-up of sediment or scale at the bottom of the pump housing, or in the reservoir.
- Remove the blockage or any dirt and scale which may have built up and close the case back up.
- Periodically change the water and keep it clean. We recommend distilled water to prevent mineral build-up. This will improve the waterfall effect.
Product Information
Specifications
- Product Name : SLIEVE BLOOM SOLAR GARDEN WATER FEATURE & PLANTER
- PLU: 145434
- Power Source: Solar panel with battery pack
- Usage: Garden water feature and planter
- Operating Time: 6-8 hours on full battery charge
FAQ
Q: What should I do if the pump has air on first use?
A: Allow several minutes for all air to escape from the pump during
initial use.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>