Smd Technologies VK-3134 Volkano Pumped Series Wearable Speaker with Armband User Manual
- June 5, 2024
- Smd Technologies
Table of Contents
VK-3134 Volkano Pumped Series Wearable Speaker with Armband
User Manual
Product Illustration
-
Power on/off: Press for 3 seconds; Short press to play/ pause.
-
Short press for mode switch (Camera mode / MicroSD Mode / Bluetooth mode) When Bluetooth is connected with a mobile phone, short press the mode button to answer/end the call or long-press the button to reject the call.
-
Press once, track forward, hold on to the key, and volume up.
-
Press once, trackback, hold on the key, volume down.
-
Long press to enter camera mode, open the phone camera, and short press the selfie button to take phones.
-
Micro SD.
-
Micro USB for charging
-
LED Indicates
Turn on: Blue light twinkles, the device is waiting for Bluetooth to connect.
After connecting successfully, the blue light it on.
Music play: Blue light flashes slowly.
Charging: Red LED Glows.
Full charge: Red LED off. -
Microphone
Features:
Wireless BT
Supports Micro SD card
Camera shutter mode
Media /Volume control
Call function
Built-in rechargeable battery
Warning:
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Statement:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>