HOSE MONSTER 2AZQLSMARTMONSTER Smart Pressure Gauge User Guide
- June 5, 2024
- HOSE MONSTER
Table of Contents
Smart Monster
Smart Pressure Gauge for Hose Monster products
Introduction
About your Smart Monster
The Smart Monster is a smart, wireless pressure sensor for use with Hose
Monster products. To begin, download and install the Smart Monster mobile
application available on both iOS and Android devices.
When you first launch the Smart Monster mobile application, you will be
prompted to allow the application to use Bluetooth communication, and on
Android, to also access location data.
These are required for the application to communicate with the Smart Monster
devices.
The mobile application will automatically discover any Smart Monster within
communication range (approximately 25 feet), and begin displaying the pressure
reading right away.
1/4” NPT Pressure Fitting
|
Wireless Charging Cap
---|---
To operate, simply connect the Smart Monster to any pressure source. Your
Smart Monster may have been supplied with a 1/4” quick fitting, which you can
replace with any 1/4” NPT fitting. Pressure readings will automatically be
shown in the mobile application.
Your Smart Monster has wireless charging capabilities. To charge the battery,
simply place it on a wireless charge pad with a wireless charge cap facing
down (the pressure fitting pointing up). The Smart Monster should reach a full
charge within 4-8 hours. It is recommended to charge them nightly, though you
should get several days’ of use out of a full charge.
Tap on any device in the list to switch to its Device Options screen. On the
Device Options screen, you can set the Hose Monster product it is connected
to, which will switch the reading shown from PSI to Gallons Per Minute (GPM).
Return to the Device Options screen and clear your selection to return to PSI
values.
Long-press on a device to open its device calibration and firmware update
screen. Unless you are instructed to do so by the Hose Monster company, do not
modify the device’s calibration values. Doing so will invalidate its
certification and result in unreliable readings.
Tap “Update Firmware” to check and install any updates to your Smart Monster
device.
PHONE
888-202-9987
FAX
847-434-0073
ADDRESS
1330 Ensell Rd
Lake Zurich, IL 60047
EMAIL
service@hosemonster.com
FCC Compliance
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
CAUTION: The grantee is not responsible for any changes or modifications
not expressly approved by the party responsible for compliance. Such
modifications could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy, and if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment has been tested and meets applicable limits for radio frequency (RF) exposure. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>