HOBK HBK-T01 Remote Control Transmitter Instructions
- June 5, 2024
- HOBK
Table of Contents
HOBK HBK-T01 Remote Control Transmitter
Introduction
This product id versatile remote control that can be used in many fields, such as access control system, wireless remote control of the lamps and other 433MHz external receivers.
Note : This remote control can only be compatible with the receivers sold in our store. If you use other sellers’ receiver, please consult us before using.
Specifications
| Operating Voltage | 6VDC (Built-in batteries) | Operating Current | 3ma |
|---|---|---|---|
| Powered By | 2pcs 3V CR2016 |
batteries
| Operating Frequency| 433.92MHz
Modulation Type| ASK| Transmit Power| 15mW
Antenna Gain| 3.6dbi| Number of Buttons| 1
Encoding Type| Fixed code| Emission Distance| max. 50m (Open aera)
Case Color| Black| Wireless Remote Control Chip| EV1527
Case Material| Plastic| Case Material| Silicone
Dimensions| 57.8L x 33.3W x 12.5H (mm) / 2-9/32″ x 1-5/16″ x 31/64″
Programming
The programming method of the transmitter depends on the receiver, please refer to the pairing method of the receiver.
How to Replace the Battery
To replace the battery, open the back case with a screwdriver, then insert batteries with positive (+)side up. Replace the batteries with 2pcs 3V CR2016 button batteries. Please dispose of the old batteries properly.
WARNING
To prevent possible serious injury or death:
- NEVER allow small children near batteries.
- If battery is swallowed, immediately notify doctor.
- To reduce the risk of the fire, explosion or chemical burn:
- Replace ONLY with 3V CR2016 button batteries.
- DO NOT recharge, disassemble, heat above 100℃ or incinerate.
FCC Caution
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>